ARM: OMAP3: cm-t35: Add regulator for ads7846 touchscreen

ads7846 driver fails to find the regulator supply and
as a result the touchscreen is not working.
Fix this by adding a regulator supply for the ads7846 driver.
Signed-off-by: Igor Grinberg <grinberg@compulab.co.il>
[tony@atomide.com: updated subject]
Signed-off-by: Tony Lindgren <tony@atomide.com>

arch/arm/mach-omap2/board-cm-t35.c

@@ -343,6 +343,10 @@ static struct regulator_consumer_supply cm_t35_vdvi_supply[] = {
 	REGULATOR_SUPPLY("vdvi", "omapdss"),
 };
 
+static struct regulator_consumer_supply cm_t35_vio_supplies[] = {
+	REGULATOR_SUPPLY("vcc", "spi1.0"),
+};
+
 /* VMMC1 for MMC1 pins CMD, CLK, DAT0..DAT3 (20 mA, plus card == max 220 mA) */
 static struct regulator_init_data cm_t35_vmmc1 = {
 	.constraints = {
@@ -373,6 +377,19 @@ static struct regulator_init_data cm_t35_vsim = {
 	.consumer_supplies	= cm_t35_vsim_supply,
 };
 
+static struct regulator_init_data cm_t35_vio = {
+	.constraints = {
+		.min_uV			= 1800000,
+		.max_uV			= 1800000,
+		.apply_uV		= true,
+		.valid_modes_mask	= REGULATOR_MODE_NORMAL
+					| REGULATOR_MODE_STANDBY,
+		.valid_ops_mask		= REGULATOR_CHANGE_MODE,
+	},
+	.num_consumer_supplies	= ARRAY_SIZE(cm_t35_vio_supplies),
+	.consumer_supplies	= cm_t35_vio_supplies,
+};
+
 static uint32_t cm_t35_keymap[] = {
 	KEY(0, 0, KEY_A),	KEY(0, 1, KEY_B),	KEY(0, 2, KEY_LEFT),
 	KEY(1, 0, KEY_UP),	KEY(1, 1, KEY_ENTER),	KEY(1, 2, KEY_DOWN),
@@ -456,6 +473,7 @@ static struct twl4030_platform_data cm_t35_twldata = {
 	.gpio		= &cm_t35_gpio_data,
 	.vmmc1		= &cm_t35_vmmc1,
 	.vsim		= &cm_t35_vsim,
+	.vio		= &cm_t35_vio,
 };
 
 static void __init cm_t35_init_i2c(void)