Commit b8b7fade authored by Maarten Lankhorst's avatar Maarten Lankhorst Committed by Jani Nikula

drm/i915: Set hwmode during readout.

This was introduced after converting hw readout to atomic,
so it should have been part of the revert too.

Bugzilla: https://bugs.freedesktop.org/show_bug.cgi?id=90929Reported-by: default avatarVille Syrjälä <ville.syrjala@linux.intel.com>
Tested-by: default avatarVille Syrjälä <ville.syrjala@linux.intel.com>
Signed-off-by: default avatarMaarten Lankhorst <maarten.lankhorst@linux.intel.com>
Signed-off-by: default avatarJani Nikula <jani.nikula@intel.com>
parent 02e0efb5
...@@ -15357,6 +15357,7 @@ static void intel_modeset_readout_hw_state(struct drm_device *dev) ...@@ -15357,6 +15357,7 @@ static void intel_modeset_readout_hw_state(struct drm_device *dev)
crtc->base.state->enable = crtc->active; crtc->base.state->enable = crtc->active;
crtc->base.state->active = crtc->active; crtc->base.state->active = crtc->active;
crtc->base.enabled = crtc->active; crtc->base.enabled = crtc->active;
crtc->base.hwmode = crtc->config->base.adjusted_mode;
plane_state = to_intel_plane_state(primary->state); plane_state = to_intel_plane_state(primary->state);
plane_state->visible = primary_get_hw_state(crtc); plane_state->visible = primary_get_hw_state(crtc);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment