Skip to content

L
linux
Commit d6b80618 authored by Wey-Yi Guy's avatar Wey-Yi Guy
Browse files
Options

iwlwifi: remove legacy isr tasklet 

After driver split, no need for support legacy isr, remove it.
Signed-off-by: default avatarWey-Yi Guy <wey-yi.w.guy@intel.com>
parent 4263108c
Show whitespace changes
Inline Side-by-side
Showing with 3 additions and 196 deletions
drivers/net/wireless/iwlwifi/iwl-agn-ict.c
View file @ d6b80618
......@@ -59,8 +59,6 @@ void iwl_free_isr_ict(struct iwl_priv *priv)
int iwl_alloc_isr_ict(struct iwl_priv *priv)
{
if (priv->cfg->base_params->use_isr_legacy)
return 0;
/* allocate shrared data table */
priv->_agn.ict_tbl_vir =
dma_alloc_coherent(&priv->pci_dev->dev,
......
drivers/net/wireless/iwlwifi/iwl-agn-lib.c
View file @ d6b80618
......@@ -652,7 +652,6 @@ int iwlagn_rx_init(struct iwl_priv *priv, struct iwl_rx_queue *rxq)
const u32 rfdnlog = RX_QUEUE_SIZE_LOG; /* 256 RBDs */
u32 rb_timeout = 0; /* FIXME: RX_RB_TIMEOUT for all devices? */
if (!priv->cfg->base_params->use_isr_legacy)
rb_timeout = RX_RB_TIMEOUT;
if (priv->cfg->mod_params->amsdu_size_8K)
......
drivers/net/wireless/iwlwifi/iwl-agn.c
View file @ d6b80618
......@@ -845,191 +845,6 @@ static inline void iwl_synchronize_irq(struct iwl_priv *priv)
tasklet_kill(&priv->irq_tasklet);
}
static void iwl_irq_tasklet_legacy(struct iwl_priv *priv)
{
u32 inta, handled = 0;
u32 inta_fh;
unsigned long flags;
u32 i;
#ifdef CONFIG_IWLWIFI_DEBUG
u32 inta_mask;
#endif
spin_lock_irqsave(&priv->lock, flags);
/* Ack/clear/reset pending uCode interrupts.
* Note: Some bits in CSR_INT are "OR" of bits in CSR_FH_INT_STATUS,
* and will clear only when CSR_FH_INT_STATUS gets cleared. */
inta = iwl_read32(priv, CSR_INT);
iwl_write32(priv, CSR_INT, inta);
/* Ack/clear/reset pending flow-handler (DMA) interrupts.
* Any new interrupts that happen after this, either while we're
* in this tasklet, or later, will show up in next ISR/tasklet. */
inta_fh = iwl_read32(priv, CSR_FH_INT_STATUS);
iwl_write32(priv, CSR_FH_INT_STATUS, inta_fh);
#ifdef CONFIG_IWLWIFI_DEBUG
if (iwl_get_debug_level(priv) & IWL_DL_ISR) {
/* just for debug */
inta_mask = iwl_read32(priv, CSR_INT_MASK);
IWL_DEBUG_ISR(priv, "inta 0x%08x, enabled 0x%08x, fh 0x%08x\n",
inta, inta_mask, inta_fh);
}
#endif
spin_unlock_irqrestore(&priv->lock, flags);
/* Since CSR_INT and CSR_FH_INT_STATUS reads and clears are not
* atomic, make sure that inta covers all the interrupts that
* we've discovered, even if FH interrupt came in just after
* reading CSR_INT. */
if (inta_fh & CSR49_FH_INT_RX_MASK)
inta |= CSR_INT_BIT_FH_RX;
if (inta_fh & CSR49_FH_INT_TX_MASK)
inta |= CSR_INT_BIT_FH_TX;
/* Now service all interrupt bits discovered above. */
if (inta & CSR_INT_BIT_HW_ERR) {
IWL_ERR(priv, "Hardware error detected. Restarting.\n");
/* Tell the device to stop sending interrupts */
iwl_disable_interrupts(priv);
priv->isr_stats.hw++;
iwl_irq_handle_error(priv);
handled |= CSR_INT_BIT_HW_ERR;
return;
}
#ifdef CONFIG_IWLWIFI_DEBUG
if (iwl_get_debug_level(priv) & (IWL_DL_ISR)) {
/* NIC fires this, but we don't use it, redundant with WAKEUP */
if (inta & CSR_INT_BIT_SCD) {
IWL_DEBUG_ISR(priv, "Scheduler finished to transmit "
"the frame/frames.\n");
priv->isr_stats.sch++;
}
/* Alive notification via Rx interrupt will do the real work */
if (inta & CSR_INT_BIT_ALIVE) {
IWL_DEBUG_ISR(priv, "Alive interrupt\n");
priv->isr_stats.alive++;
}
}
#endif
/* Safely ignore these bits for debug checks below */
inta &= ~(CSR_INT_BIT_SCD | CSR_INT_BIT_ALIVE);
/* HW RF KILL switch toggled */
if (inta & CSR_INT_BIT_RF_KILL) {
int hw_rf_kill = 0;
if (!(iwl_read32(priv, CSR_GP_CNTRL) &
CSR_GP_CNTRL_REG_FLAG_HW_RF_KILL_SW))
hw_rf_kill = 1;
IWL_WARN(priv, "RF_KILL bit toggled to %s.\n",
hw_rf_kill ? "disable radio" : "enable radio");
priv->isr_stats.rfkill++;
/* driver only loads ucode once setting the interface up.
* the driver allows loading the ucode even if the radio
* is killed. Hence update the killswitch state here. The
* rfkill handler will care about restarting if needed.
*/
if (!test_bit(STATUS_ALIVE, &priv->status)) {
if (hw_rf_kill)
set_bit(STATUS_RF_KILL_HW, &priv->status);
else
clear_bit(STATUS_RF_KILL_HW, &priv->status);
wiphy_rfkill_set_hw_state(priv->hw->wiphy, hw_rf_kill);
}
handled |= CSR_INT_BIT_RF_KILL;
}
/* Chip got too hot and stopped itself */
if (inta & CSR_INT_BIT_CT_KILL) {
IWL_ERR(priv, "Microcode CT kill error detected.\n");
priv->isr_stats.ctkill++;
handled |= CSR_INT_BIT_CT_KILL;
}
/* Error detected by uCode */
if (inta & CSR_INT_BIT_SW_ERR) {
IWL_ERR(priv, "Microcode SW error detected. "
" Restarting 0x%X.\n", inta);
priv->isr_stats.sw++;
iwl_irq_handle_error(priv);
handled |= CSR_INT_BIT_SW_ERR;
}
/*
* uCode wakes up after power-down sleep.
* Tell device about any new tx or host commands enqueued,
* and about any Rx buffers made available while asleep.
*/
if (inta & CSR_INT_BIT_WAKEUP) {
IWL_DEBUG_ISR(priv, "Wakeup interrupt\n");
iwl_rx_queue_update_write_ptr(priv, &priv->rxq);
for (i = 0; i < priv->hw_params.max_txq_num; i++)
iwl_txq_update_write_ptr(priv, &priv->txq[i]);
priv->isr_stats.wakeup++;
handled |= CSR_INT_BIT_WAKEUP;
}
/* All uCode command responses, including Tx command responses,
* Rx "responses" (frame-received notification), and other
* notifications from uCode come through here*/
if (inta & (CSR_INT_BIT_FH_RX | CSR_INT_BIT_SW_RX)) {
iwl_rx_handle(priv);
priv->isr_stats.rx++;
handled |= (CSR_INT_BIT_FH_RX | CSR_INT_BIT_SW_RX);
}
/* This "Tx" DMA channel is used only for loading uCode */
if (inta & CSR_INT_BIT_FH_TX) {
IWL_DEBUG_ISR(priv, "uCode load interrupt\n");
priv->isr_stats.tx++;
handled |= CSR_INT_BIT_FH_TX;
/* Wake up uCode load routine, now that load is complete */
priv->ucode_write_complete = 1;
wake_up_interruptible(&priv->wait_command_queue);
}
if (inta & ~handled) {
IWL_ERR(priv, "Unhandled INTA bits 0x%08x\n", inta & ~handled);
priv->isr_stats.unhandled++;
}
if (inta & ~(priv->inta_mask)) {
IWL_WARN(priv, "Disabled INTA bits 0x%08x were pending\n",
inta & ~priv->inta_mask);
IWL_WARN(priv, " with FH_INT = 0x%08x\n", inta_fh);
}
/* Re-enable all interrupts */
/* only Re-enable if disabled by irq */
if (test_bit(STATUS_INT_ENABLED, &priv->status))
iwl_enable_interrupts(priv);
/* Re-enable RF_KILL if it occurred */
else if (handled & CSR_INT_BIT_RF_KILL)
iwl_enable_rfkill_int(priv);
#ifdef CONFIG_IWLWIFI_DEBUG
if (iwl_get_debug_level(priv) & (IWL_DL_ISR)) {
inta = iwl_read32(priv, CSR_INT);
inta_mask = iwl_read32(priv, CSR_INT_MASK);
inta_fh = iwl_read32(priv, CSR_FH_INT_STATUS);
IWL_DEBUG_ISR(priv, "End inta 0x%08x, enabled 0x%08x, fh 0x%08x, "
"flags 0x%08lx\n", inta, inta_mask, inta_fh, flags);
}
#endif
}
/* tasklet for iwlagn interrupt */
static void iwl_irq_tasklet(struct iwl_priv *priv)
{
......@@ -3751,12 +3566,8 @@ static void iwl_setup_deferred_work(struct iwl_priv *priv)
priv->watchdog.data = (unsigned long)priv;
priv->watchdog.function = iwl_bg_watchdog;
if (!priv->cfg->base_params->use_isr_legacy)
tasklet_init(&priv->irq_tasklet, (void (*)(unsigned long))
iwl_irq_tasklet, (unsigned long)priv);
else
tasklet_init(&priv->irq_tasklet, (void (*)(unsigned long))
iwl_irq_tasklet_legacy, (unsigned long)priv);
}
static void iwl_cancel_deferred_work(struct iwl_priv *priv)
......
drivers/net/wireless/iwlwifi/iwl-core.h
View file @ d6b80618
......@@ -291,7 +291,6 @@ struct iwl_base_params {
bool set_l0s;
bool use_bsm;
bool use_isr_legacy;
const u16 max_ll_items;
const bool shadow_ram_support;
u16 led_compensation;
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment
GitLab Nexedi Edition | About GitLab | About Nexedi | 沪ICP备2021021310号-2 | 沪ICP备2021021310号-7