net: qcom/emac: specify the correct DMA mask

The 64/32-bit DMA mask hackery in the EMAC driver is not actually necessary,
and is technically not accurate.  The EMAC hardware is limted to a 45-bit
DMA address.  Although no EMAC-enabled system can have that much DDR,
an IOMMU could possible provide a larger address.  Rather than play games
with the DMA mappings, the driver should provide a correct value and
trust the DMA/IOMMU layers to do the right thing.
Signed-off-by: Timur Tabi <timur@codeaurora.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/qualcomm/emac/emac.c

@@ -615,21 +615,12 @@ static int emac_probe(struct platform_device *pdev)
 	u32 reg;
 	int ret;
 
-	/* The EMAC itself is capable of 64-bit DMA, so try that first. */
-	ret = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(64));
-	if (ret) {
-		/* Some platforms may restrict the EMAC's address bus to less
-		 * then the size of DDR. In this case, we need to try a
-		 * smaller mask.  We could try every possible smaller mask,
-		 * but that's overkill.  Instead, just fall to 32-bit, which
-		 * should always work.
-		 */
-		ret = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(32));
+	/* The TPD buffer address is limited to 45 bits. */
+	ret = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(45));
 	if (ret) {
 		dev_err(&pdev->dev, "could not set DMA mask\n");
 		return ret;
 	}
-	}
 
 	netdev = alloc_etherdev(sizeof(struct emac_adapter));
 	if (!netdev)