PCI: qcom: Add support for SDM845 PCIe controller

The SDM845 has one Gen2 and one Gen3 controller, add support for these.
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Signed-off-by: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Reviewed-by: Vinod Koul <vkoul@kernel.org>
Reviewed-by: Philipp Zabel <p.zabel@pengutronix.de>
Reviewed-by: Andrew Murray <andrew.murray@arm.com>
Acked-by: Stanimir Varbanov <svarbanov@mm-sol.com>

drivers/pci/controller/dwc/pcie-qcom.c

@@ -54,6 +54,7 @@
 #define PCIE20_PARF_LTSSM			0x1B0
 #define PCIE20_PARF_SID_OFFSET			0x234
 #define PCIE20_PARF_BDF_TRANSLATE_CFG		0x24C
+#define PCIE20_PARF_DEVICE_TYPE			0x1000
 
 #define PCIE20_ELBI_SYS_CTRL			0x04
 #define PCIE20_ELBI_SYS_CTRL_LT_ENABLE		BIT(0)
@@ -80,6 +81,8 @@
 #define PCIE20_v3_PARF_SLV_ADDR_SPACE_SIZE	0x358
 #define SLV_ADDR_SPACE_SZ			0x10000000
 
+#define DEVICE_TYPE_RC				0x4
+
 #define QCOM_PCIE_2_1_0_MAX_SUPPLY	3
 struct qcom_pcie_resources_2_1_0 {
 	struct clk *iface_clk;
@@ -139,12 +142,20 @@ struct qcom_pcie_resources_2_3_3 {
 	struct reset_control *rst[7];
 };
 
+struct qcom_pcie_resources_2_7_0 {
+	struct clk_bulk_data clks[6];
+	struct regulator_bulk_data supplies[2];
+	struct reset_control *pci_reset;
+	struct clk *pipe_clk;
+};
+
 union qcom_pcie_resources {
 	struct qcom_pcie_resources_1_0_0 v1_0_0;
 	struct qcom_pcie_resources_2_1_0 v2_1_0;
 	struct qcom_pcie_resources_2_3_2 v2_3_2;
 	struct qcom_pcie_resources_2_3_3 v2_3_3;
 	struct qcom_pcie_resources_2_4_0 v2_4_0;
+	struct qcom_pcie_resources_2_7_0 v2_7_0;
 };
 
 struct qcom_pcie;
@@ -1068,6 +1079,134 @@ static int qcom_pcie_init_2_3_3(struct qcom_pcie *pcie)
 	return ret;
 }
 
+static int qcom_pcie_get_resources_2_7_0(struct qcom_pcie *pcie)
+{
+	struct qcom_pcie_resources_2_7_0 *res = &pcie->res.v2_7_0;
+	struct dw_pcie *pci = pcie->pci;
+	struct device *dev = pci->dev;
+	int ret;
+
+	res->pci_reset = devm_reset_control_get_exclusive(dev, "pci");
+	if (IS_ERR(res->pci_reset))
+		return PTR_ERR(res->pci_reset);
+
+	res->supplies[0].supply = "vdda";
+	res->supplies[1].supply = "vddpe-3v3";
+	ret = devm_regulator_bulk_get(dev, ARRAY_SIZE(res->supplies),
+				      res->supplies);
+	if (ret)
+		return ret;
+
+	res->clks[0].id = "aux";
+	res->clks[1].id = "cfg";
+	res->clks[2].id = "bus_master";
+	res->clks[3].id = "bus_slave";
+	res->clks[4].id = "slave_q2a";
+	res->clks[5].id = "tbu";
+
+	ret = devm_clk_bulk_get(dev, ARRAY_SIZE(res->clks), res->clks);
+	if (ret < 0)
+		return ret;
+
+	res->pipe_clk = devm_clk_get(dev, "pipe");
+	return PTR_ERR_OR_ZERO(res->pipe_clk);
+}
+
+static int qcom_pcie_init_2_7_0(struct qcom_pcie *pcie)
+{
+	struct qcom_pcie_resources_2_7_0 *res = &pcie->res.v2_7_0;
+	struct dw_pcie *pci = pcie->pci;
+	struct device *dev = pci->dev;
+	u32 val;
+	int ret;
+
+	ret = regulator_bulk_enable(ARRAY_SIZE(res->supplies), res->supplies);
+	if (ret < 0) {
+		dev_err(dev, "cannot enable regulators\n");
+		return ret;
+	}
+
+	ret = clk_bulk_prepare_enable(ARRAY_SIZE(res->clks), res->clks);
+	if (ret < 0)
+		goto err_disable_regulators;
+
+	ret = reset_control_assert(res->pci_reset);
+	if (ret < 0) {
+		dev_err(dev, "cannot deassert pci reset\n");
+		goto err_disable_clocks;
+	}
+
+	usleep_range(1000, 1500);
+
+	ret = reset_control_deassert(res->pci_reset);
+	if (ret < 0) {
+		dev_err(dev, "cannot deassert pci reset\n");
+		goto err_disable_clocks;
+	}
+
+	ret = clk_prepare_enable(res->pipe_clk);
+	if (ret) {
+		dev_err(dev, "cannot prepare/enable pipe clock\n");
+		goto err_disable_clocks;
+	}
+
+	/* configure PCIe to RC mode */
+	writel(DEVICE_TYPE_RC, pcie->parf + PCIE20_PARF_DEVICE_TYPE);
+
+	/* enable PCIe clocks and resets */
+	val = readl(pcie->parf + PCIE20_PARF_PHY_CTRL);
+	val &= ~BIT(0);
+	writel(val, pcie->parf + PCIE20_PARF_PHY_CTRL);
+
+	/* change DBI base address */
+	writel(0, pcie->parf + PCIE20_PARF_DBI_BASE_ADDR);
+
+	/* MAC PHY_POWERDOWN MUX DISABLE  */
+	val = readl(pcie->parf + PCIE20_PARF_SYS_CTRL);
+	val &= ~BIT(29);
+	writel(val, pcie->parf + PCIE20_PARF_SYS_CTRL);
+
+	val = readl(pcie->parf + PCIE20_PARF_MHI_CLOCK_RESET_CTRL);
+	val |= BIT(4);
+	writel(val, pcie->parf + PCIE20_PARF_MHI_CLOCK_RESET_CTRL);
+
+	if (IS_ENABLED(CONFIG_PCI_MSI)) {
+		val = readl(pcie->parf + PCIE20_PARF_AXI_MSTR_WR_ADDR_HALT);
+		val |= BIT(31);
+		writel(val, pcie->parf + PCIE20_PARF_AXI_MSTR_WR_ADDR_HALT);
+	}
+
+	return 0;
+err_disable_clocks:
+	clk_bulk_disable_unprepare(ARRAY_SIZE(res->clks), res->clks);
+err_disable_regulators:
+	regulator_bulk_disable(ARRAY_SIZE(res->supplies), res->supplies);
+
+	return ret;
+}
+
+static void qcom_pcie_deinit_2_7_0(struct qcom_pcie *pcie)
+{
+	struct qcom_pcie_resources_2_7_0 *res = &pcie->res.v2_7_0;
+
+	clk_bulk_disable_unprepare(ARRAY_SIZE(res->clks), res->clks);
+	regulator_bulk_disable(ARRAY_SIZE(res->supplies), res->supplies);
+}
+
+static int qcom_pcie_post_init_2_7_0(struct qcom_pcie *pcie)
+{
+	struct qcom_pcie_resources_2_7_0 *res = &pcie->res.v2_7_0;
+
+	return clk_prepare_enable(res->pipe_clk);
+}
+
+static void qcom_pcie_post_deinit_2_7_0(struct qcom_pcie *pcie)
+{
+	struct qcom_pcie_resources_2_7_0 *res = &pcie->res.v2_7_0;
+
+	clk_disable_unprepare(res->pipe_clk);
+}
+
 static int qcom_pcie_link_up(struct dw_pcie *pci)
 {
 	u16 val = readw(pci->dbi_base + PCIE20_CAP + PCI_EXP_LNKSTA);
@@ -1167,6 +1306,16 @@ static const struct qcom_pcie_ops ops_2_3_3 = {
 	.ltssm_enable = qcom_pcie_2_3_2_ltssm_enable,
 };
 
+/* Qcom IP rev.: 2.7.0	Synopsys IP rev.: 4.30a */
+static const struct qcom_pcie_ops ops_2_7_0 = {
+	.get_resources = qcom_pcie_get_resources_2_7_0,
+	.init = qcom_pcie_init_2_7_0,
+	.deinit = qcom_pcie_deinit_2_7_0,
+	.ltssm_enable = qcom_pcie_2_3_2_ltssm_enable,
+	.post_init = qcom_pcie_post_init_2_7_0,
+	.post_deinit = qcom_pcie_post_deinit_2_7_0,
+};
+
 static const struct dw_pcie_ops dw_pcie_ops = {
 	.link_up = qcom_pcie_link_up,
 };
@@ -1282,6 +1431,7 @@ static const struct of_device_id qcom_pcie_match[] = {
 	{ .compatible = "qcom,pcie-ipq8074", .data = &ops_2_3_3 },
 	{ .compatible = "qcom,pcie-ipq4019", .data = &ops_2_4_0 },
 	{ .compatible = "qcom,pcie-qcs404", .data = &ops_2_4_0 },
+	{ .compatible = "qcom,pcie-sdm845", .data = &ops_2_7_0 },
 	{ }
 };