Merge tag 'for-linus-20130509' of git://git.infradead.org/~dwmw2/random-2.6

Pull misc fixes from David Woodhouse:
 "This is some miscellaneous cleanups that don't really belong anywhere
  else (or were ignored), that have been sitting in linux-next for some
  time.  Two of them are fixes resulting from my audit of krealloc()
  usage that don't seem to have elicited any response when I posted
  them, and the other three are patches from Artem removing dead code."

* tag 'for-linus-20130509' of git://git.infradead.org/~dwmw2/random-2.6:
  pcmcia: remove RPX board stuff
  m68k: remove rpxlite stuff
  pcmcia: remove Motorola MBX860 support
  params: Fix potential memory leak in add_sysfs_param()
  dell-laptop: Fix krealloc() misuse in parse_da_table()

arch/m68k/include/asm/commproc.h

@@ -480,23 +480,6 @@ typedef struct scc_enet {
 #define SICR_ENET_CLKRT	((uint)0x0000003d)
 #endif
 
-#ifdef CONFIG_RPXLITE
-/* This ENET stuff is for the MPC850 with ethernet on SCC2.  Some of
- * this may be unique to the RPX-Lite configuration.
- * Note TENA is on Port B.
- */
-#define PA_ENET_RXD	((ushort)0x0004)
-#define PA_ENET_TXD	((ushort)0x0008)
-#define PA_ENET_TCLK	((ushort)0x0200)
-#define PA_ENET_RCLK	((ushort)0x0800)
-#define PB_ENET_TENA	((uint)0x00002000)
-#define PC_ENET_CLSN	((ushort)0x0040)
-#define PC_ENET_RENA	((ushort)0x0080)
-
-#define SICR_ENET_MASK	((uint)0x0000ff00)
-#define SICR_ENET_CLKRT	((uint)0x00003d00)
-#endif
-
 #ifdef CONFIG_BSEIP
 /* This ENET stuff is for the MPC823 with ethernet on SCC2.
  * This is unique to the BSE ip-Engine board.

drivers/pcmcia/m8xx_pcmcia.c

@@ -68,12 +68,6 @@ MODULE_LICENSE("Dual MPL/GPL");
 
 #if !defined(CONFIG_PCMCIA_SLOT_A) && !defined(CONFIG_PCMCIA_SLOT_B)
 
-/* The RPX series use SLOT_B */
-#if defined(CONFIG_RPXCLASSIC) || defined(CONFIG_RPXLITE)
-#define CONFIG_PCMCIA_SLOT_B
-#define CONFIG_BD_IS_MHZ
-#endif
-
 /* The ADS board use SLOT_A */
 #ifdef CONFIG_ADS
 #define CONFIG_PCMCIA_SLOT_A
@@ -253,81 +247,6 @@ static irqreturn_t m8xx_interrupt(int irq, void *dev);
 
 #define PCMCIA_BMT_LIMIT (15*4)	/* Bus Monitor Timeout value */
 
-/* ------------------------------------------------------------------------- */
-/* board specific stuff:                                                     */
-/* voltage_set(), hardware_enable() and hardware_disable()                   */
-/* ------------------------------------------------------------------------- */
-/* RPX Boards from Embedded Planet                                           */
-
-#if defined(CONFIG_RPXCLASSIC) || defined(CONFIG_RPXLITE)
-
-/* The RPX boards seems to have it's bus monitor timeout set to 6*8 clocks.
- * SYPCR is write once only, therefore must the slowest memory be faster
- * than the bus monitor or we will get a machine check due to the bus timeout.
- */
-
-#define PCMCIA_BOARD_MSG "RPX CLASSIC or RPX LITE"
-
-#undef PCMCIA_BMT_LIMIT
-#define PCMCIA_BMT_LIMIT (6*8)
-
-static int voltage_set(int slot, int vcc, int vpp)
-{
-	u32 reg = 0;
-
-	switch (vcc) {
-	case 0:
-		break;
-	case 33:
-		reg |= BCSR1_PCVCTL4;
-		break;
-	case 50:
-		reg |= BCSR1_PCVCTL5;
-		break;
-	default:
-		return 1;
-	}
-
-	switch (vpp) {
-	case 0:
-		break;
-	case 33:
-	case 50:
-		if (vcc == vpp)
-			reg |= BCSR1_PCVCTL6;
-		else
-			return 1;
-		break;
-	case 120:
-		reg |= BCSR1_PCVCTL7;
-	default:
-		return 1;
-	}
-
-	if (!((vcc == 50) || (vcc == 0)))
-		return 1;
-
-	/* first, turn off all power */
-
-	out_be32(((u32 *) RPX_CSR_ADDR),
-		 in_be32(((u32 *) RPX_CSR_ADDR)) & ~(BCSR1_PCVCTL4 |
-						     BCSR1_PCVCTL5 |
-						     BCSR1_PCVCTL6 |
-						     BCSR1_PCVCTL7));
-
-	/* enable new powersettings */
-
-	out_be32(((u32 *) RPX_CSR_ADDR), in_be32(((u32 *) RPX_CSR_ADDR)) | reg);
-
-	return 0;
-}
-
-#define socket_get(_slot_) PCMCIA_SOCKET_KEY_5V
-#define hardware_enable(_slot_)	/* No hardware to enable */
-#define hardware_disable(_slot_)	/* No hardware to disable */
-
-#endif				/* CONFIG_RPXCLASSIC */
-
 /* FADS Boards from Motorola                                               */
 
 #if defined(CONFIG_FADS)
@@ -419,65 +338,6 @@ static inline int voltage_set(int slot, int vcc, int vpp)
 
 #endif
 
-/* ------------------------------------------------------------------------- */
-/* Motorola MBX860                                                           */
-
-#if defined(CONFIG_MBX)
-
-#define PCMCIA_BOARD_MSG "MBX"
-
-static int voltage_set(int slot, int vcc, int vpp)
-{
-	u8 reg = 0;
-
-	switch (vcc) {
-	case 0:
-		break;
-	case 33:
-		reg |= CSR2_VCC_33;
-		break;
-	case 50:
-		reg |= CSR2_VCC_50;
-		break;
-	default:
-		return 1;
-	}
-
-	switch (vpp) {
-	case 0:
-		break;
-	case 33:
-	case 50:
-		if (vcc == vpp)
-			reg |= CSR2_VPP_VCC;
-		else
-			return 1;
-		break;
-	case 120:
-		if ((vcc == 33) || (vcc == 50))
-			reg |= CSR2_VPP_12;
-		else
-			return 1;
-	default:
-		return 1;
-	}
-
-	/* first, turn off all power */
-	out_8((u8 *) MBX_CSR2_ADDR,
-	      in_8((u8 *) MBX_CSR2_ADDR) & ~(CSR2_VCC_MASK | CSR2_VPP_MASK));
-
-	/* enable new powersettings */
-	out_8((u8 *) MBX_CSR2_ADDR, in_8((u8 *) MBX_CSR2_ADDR) | reg);
-
-	return 0;
-}
-
-#define socket_get(_slot_) PCMCIA_SOCKET_KEY_5V
-#define hardware_enable(_slot_)	/* No hardware to enable */
-#define hardware_disable(_slot_)	/* No hardware to disable */
-
-#endif				/* CONFIG_MBX */
-
 #if defined(CONFIG_PRxK)
 #include <asm/cpld.h>
 extern volatile fpga_pc_regs *fpga_pc;

drivers/platform/x86/dell-laptop.c

@@ -284,6 +284,7 @@ static void __init parse_da_table(const struct dmi_header *dm)
 {
 	/* Final token is a terminator, so we don't want to copy it */
 	int tokens = (dm->length-11)/sizeof(struct calling_interface_token)-1;
+	struct calling_interface_token *new_da_tokens;
 	struct calling_interface_structure *table =
 		container_of(dm, struct calling_interface_structure, header);
 
@@ -296,12 +297,13 @@ static void __init parse_da_table(const struct dmi_header *dm)
 	da_command_address = table->cmdIOAddress;
 	da_command_code = table->cmdIOCode;
 
-	da_tokens = krealloc(da_tokens, (da_num_tokens + tokens) *
+	new_da_tokens = krealloc(da_tokens, (da_num_tokens + tokens) *
 				 sizeof(struct calling_interface_token),
 				 GFP_KERNEL);
 
-	if (!da_tokens)
+	if (!new_da_tokens)
 		return;
+	da_tokens = new_da_tokens;
 
 	memcpy(da_tokens+da_num_tokens, table->tokens,
 	       sizeof(struct calling_interface_token) * tokens);

kernel/params.c

@@ -613,10 +613,13 @@ static __modinit int add_sysfs_param(struct module_kobject *mk,
 		       sizeof(*mk->mp) + sizeof(mk->mp->attrs[0]) * (num+1),
 		       GFP_KERNEL);
 	if (!new) {
-		kfree(mk->mp);
+		kfree(attrs);
 		err = -ENOMEM;
 		goto fail;
 	}
+	/* Despite looking like the typical realloc() bug, this is safe.
+	 * We *want* the old 'attrs' to be freed either way, and we'll store
+	 * the new one in the success case. */
 	attrs = krealloc(attrs, sizeof(new->grp.attrs[0])*(num+2), GFP_KERNEL);
 	if (!attrs) {
 		err = -ENOMEM;