Commit 05a34f51 authored by Julia Lawall's avatar Julia Lawall Committed by Jesse Barnes

PCI hotplug: fix logic in Compaq hotplug controller bus speed setup

The pattern !E && !E->fld is nonsensical.  The patch below updates this
according to the assumption that && should be ||.  But perhaps another
solution was intended.

The semantic patch that makes this change is as follows:
(http://www.emn.fr/x-info/coccinelle/)

// <smpl>
@disable and_comm@
expression E;
identifier fld;
@@

- !E && !E->fld
+ !E || !E->fld
// </smpl>
Signed-off-by: default avatarJulia Lawall <julia@diku.dk>
Reviewed-by: default avatarMatthew Wilcox <willy@linux.intel.com>
Signed-off-by: default avatarAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: default avatarJesse Barnes <jbarnes@virtuousgeek.org>
parent 1388cc96
...@@ -1139,7 +1139,7 @@ static u8 set_controller_speed(struct controller *ctrl, u8 adapter_speed, u8 hp_ ...@@ -1139,7 +1139,7 @@ static u8 set_controller_speed(struct controller *ctrl, u8 adapter_speed, u8 hp_
for(slot = ctrl->slot; slot; slot = slot->next) { for(slot = ctrl->slot; slot; slot = slot->next) {
if (slot->device == (hp_slot + ctrl->slot_device_offset)) if (slot->device == (hp_slot + ctrl->slot_device_offset))
continue; continue;
if (!slot->hotplug_slot && !slot->hotplug_slot->info) if (!slot->hotplug_slot || !slot->hotplug_slot->info)
continue; continue;
if (slot->hotplug_slot->info->adapter_status == 0) if (slot->hotplug_slot->info->adapter_status == 0)
continue; continue;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment