Commit 06b7a631 authored by Yixun Lan's avatar Yixun Lan Committed by Kevin Hilman

arm64: dts: meson-axg: switch uart_ao clock to CLK81

Switch the uart_ao pclk to CLK81 since the clock driver is ready.
Signed-off-by: default avatarYixun Lan <yixun.lan@amlogic.com>
Reviewed-by: default avatarNeil Armstrong <narmstrong@baylibre.com>
Signed-off-by: default avatarKevin Hilman <khilman@baylibre.com>
parent fbaf05f4
...@@ -7,6 +7,7 @@ ...@@ -7,6 +7,7 @@
#include <dt-bindings/gpio/gpio.h> #include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/interrupt-controller/irq.h> #include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/interrupt-controller/arm-gic.h> #include <dt-bindings/interrupt-controller/arm-gic.h>
#include <dt-bindings/clock/axg-clkc.h>
/ { / {
compatible = "amlogic,meson-axg"; compatible = "amlogic,meson-axg";
...@@ -361,7 +362,7 @@ uart_AO: serial@3000 { ...@@ -361,7 +362,7 @@ uart_AO: serial@3000 {
compatible = "amlogic,meson-gx-uart", "amlogic,meson-ao-uart"; compatible = "amlogic,meson-gx-uart", "amlogic,meson-ao-uart";
reg = <0x0 0x3000 0x0 0x18>; reg = <0x0 0x3000 0x0 0x18>;
interrupts = <GIC_SPI 193 IRQ_TYPE_EDGE_RISING>; interrupts = <GIC_SPI 193 IRQ_TYPE_EDGE_RISING>;
clocks = <&xtal>, <&xtal>, <&xtal>; clocks = <&xtal>, <&clkc CLKID_CLK81>, <&xtal>;
clock-names = "xtal", "pclk", "baud"; clock-names = "xtal", "pclk", "baud";
status = "disabled"; status = "disabled";
}; };
...@@ -370,7 +371,7 @@ uart_AO_B: serial@4000 { ...@@ -370,7 +371,7 @@ uart_AO_B: serial@4000 {
compatible = "amlogic,meson-gx-uart", "amlogic,meson-ao-uart"; compatible = "amlogic,meson-gx-uart", "amlogic,meson-ao-uart";
reg = <0x0 0x4000 0x0 0x18>; reg = <0x0 0x4000 0x0 0x18>;
interrupts = <GIC_SPI 197 IRQ_TYPE_EDGE_RISING>; interrupts = <GIC_SPI 197 IRQ_TYPE_EDGE_RISING>;
clocks = <&xtal>, <&xtal>, <&xtal>; clocks = <&xtal>, <&clkc CLKID_CLK81>, <&xtal>;
clock-names = "xtal", "pclk", "baud"; clock-names = "xtal", "pclk", "baud";
status = "disabled"; status = "disabled";
}; };
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment