Commit 09b4f706 authored by Ludovic Barre's avatar Ludovic Barre Committed by Ulf Hansson

mmc: mmci: send stop command if sbc error issue

Refer to "4.15 set block count command" of sd specification:
Host needs to issue CMD12 if any error is detected in
the CMD18 and CMD25 operations.

In sbc case, the data->stop is fill by framework.
Signed-off-by: default avatarLudovic Barre <ludovic.barre@st.com>
Tested-by: default avatarUlf Hansson <ulf.hansson@linaro.org>
Signed-off-by: default avatarUlf Hansson <ulf.hansson@linaro.org>
parent 20427e5d
...@@ -1190,12 +1190,11 @@ mmci_data_irq(struct mmci_host *host, struct mmc_data *data, ...@@ -1190,12 +1190,11 @@ mmci_data_irq(struct mmci_host *host, struct mmc_data *data,
/* The error clause is handled above, success! */ /* The error clause is handled above, success! */
data->bytes_xfered = data->blksz * data->blocks; data->bytes_xfered = data->blksz * data->blocks;
if (!data->stop || host->mrq->sbc) { if (!data->stop || (host->mrq->sbc && !data->error))
mmci_request_end(host, data->mrq); mmci_request_end(host, data->mrq);
} else { else
mmci_start_command(host, data->stop, 0); mmci_start_command(host, data->stop, 0);
} }
}
} }
static void static void
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment