mlxsw: spectrum: Prevent force of 56G

Force of 56G is not supported by hardware in Ethernet devices. This
configuration fails with a bad parameter error from firmware.

Add check of this case. Instead of trying to set 56G with autoneg off,
return a meaningful error.

Fixes: 56ade8fe ("mlxsw: spectrum: Add initial support for Spectrum ASIC")
Signed-off-by: Amit Cohen <amitc@mellanox.com>
Acked-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/mellanox/mlxsw/spectrum.c

@@ -3128,6 +3128,10 @@ mlxsw_sp_port_set_link_ksettings(struct net_device *dev,
 	ops->reg_ptys_eth_unpack(mlxsw_sp, ptys_pl, &eth_proto_cap, NULL, NULL);
 
 	autoneg = cmd->base.autoneg == AUTONEG_ENABLE;
+	if (!autoneg && cmd->base.speed == SPEED_56000) {
+		netdev_err(dev, "56G not supported with autoneg off\n");
+		return -EINVAL;
+	}
 	eth_proto_new = autoneg ?
 		ops->to_ptys_advert_link(mlxsw_sp, cmd) :
 		ops->to_ptys_speed(mlxsw_sp, cmd->base.speed);