arm64: dts: exynos: Remove the te-gpios property in the TM2 boards

The decon uses HW-TRIGGER, so TE interrupt is not necessary.
Therefore, remove the te-gpios property in the TM2 dts.
Signed-off-by: Hoegeun Kwon <hoegeun.kwon@samsung.com>
Reviewed-by: Inki Dae <inki.dae@samsung.com>
Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>

arch/arm64/boot/dts/exynos/exynos5433-tm2.dts

@@ -60,7 +60,6 @@ panel@0 {
 		vci-supply = <&ldo28_reg>;
 		reset-gpios = <&gpg0 0 GPIO_ACTIVE_LOW>;
 		enable-gpios = <&gpf1 5 GPIO_ACTIVE_HIGH>;
-		te-gpios = <&gpf1 3 GPIO_ACTIVE_HIGH>;
 	};
 };