Commit 355b3552 authored by Pierre-Louis Bossart's avatar Pierre-Louis Bossart Committed by Mark Brown

ASoC: Intel: cht_bsw_max98090: add gpio-based jack detection

Jacks are created but only enabled when the external TI chip is
present, this probably never worked as well. Forklift the gpio-based
code from the legacy byt-max98090 driver, with however a less strict
error check. It's fine to let users enjoy their device even if
jack detection doesn't work - it almost never does without quirks...

Tested on Lenovo100s
Signed-off-by: default avatarPierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Acked-By: default avatarVinod Koul <vinod.koul@intel.com>
Signed-off-by: default avatarMark Brown <broonie@kernel.org>
parent 3bbda5a3
......@@ -159,6 +159,40 @@ static struct notifier_block cht_jack_nb = {
.notifier_call = cht_ti_jack_event,
};
static struct snd_soc_jack_pin hs_jack_pins[] = {
{
.pin = "Headphone",
.mask = SND_JACK_HEADPHONE,
},
{
.pin = "Headset Mic",
.mask = SND_JACK_MICROPHONE,
},
};
static struct snd_soc_jack_gpio hs_jack_gpios[] = {
{
.name = "hp",
.report = SND_JACK_HEADPHONE | SND_JACK_LINEOUT,
.debounce_time = 200,
},
{
.name = "mic",
.invert = 1,
.report = SND_JACK_MICROPHONE,
.debounce_time = 200,
},
};
static const struct acpi_gpio_params hp_gpios = { 0, 0, false };
static const struct acpi_gpio_params mic_gpios = { 1, 0, false };
static const struct acpi_gpio_mapping acpi_max98090_gpios[] = {
{ "hp-gpios", &hp_gpios, 1 },
{ "mic-gpios", &mic_gpios, 1 },
{},
};
static int cht_codec_init(struct snd_soc_pcm_runtime *runtime)
{
int ret;
......@@ -178,15 +212,29 @@ static int cht_codec_init(struct snd_soc_pcm_runtime *runtime)
jack_type = SND_JACK_HEADPHONE | SND_JACK_MICROPHONE;
ret = snd_soc_card_jack_new(runtime->card, "Headset Jack",
jack_type, jack, NULL, 0);
jack_type, jack,
hs_jack_pins, ARRAY_SIZE(hs_jack_pins));
if (ret) {
dev_err(runtime->dev, "Headset Jack creation failed %d\n", ret);
return ret;
}
if (ctx->ts3a227e_present)
snd_soc_jack_notifier_register(jack, &cht_jack_nb);
ret = snd_soc_jack_add_gpiods(runtime->card->dev->parent, jack,
ARRAY_SIZE(hs_jack_gpios),
hs_jack_gpios);
if (ret) {
/*
* flag error but don't bail if jack detect is broken
* due to platform issues or bad BIOS/configuration
*/
dev_err(runtime->dev,
"jack detection gpios not added, error %d\n", ret);
}
/*
* The firmware might enable the clock at
* boot (this information may or may not
......@@ -363,6 +411,7 @@ static struct snd_soc_card snd_soc_card_cht = {
static int snd_cht_mc_probe(struct platform_device *pdev)
{
struct device *dev = &pdev->dev;
int ret_val = 0;
struct cht_mc_private *drv;
......@@ -375,6 +424,11 @@ static int snd_cht_mc_probe(struct platform_device *pdev)
/* no need probe TI jack detection chip */
snd_soc_card_cht.aux_dev = NULL;
snd_soc_card_cht.num_aux_devs = 0;
ret_val = devm_acpi_dev_add_driver_gpios(dev->parent,
acpi_max98090_gpios);
if (ret_val)
dev_dbg(dev, "Unable to add GPIO mapping table\n");
}
/* register the soc card */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment