Commit 39ad2cb3 authored by Matthias Urlichs's avatar Matthias Urlichs Committed by Linus Torvalds

m68k: Mac89x0 Ethernet netif updates

Macintosh CS89x0 Ethernet: Netif updates
Addition of netif_stop_queue() before transmission by Michael Schmitz
skb_copy_{from,to}_linear_data() conversion by Geert Uytterhoeven
Signed-off-by: default avatarGeert Uytterhoeven <geert@linux-m68k.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@linux-foundation.org>
parent ec0203e7
......@@ -311,7 +311,7 @@ config MAC8390
config MAC89x0
tristate "Macintosh CS89x0 based ethernet cards"
depends on NET_ETHERNET && MAC && BROKEN
depends on NET_ETHERNET && MAC
---help---
Support for CS89x0 chipset based Ethernet cards. If you have a
Nubus or LC-PDS network (Ethernet) card of this type, say Y and
......
......@@ -374,24 +374,6 @@ net_open(struct net_device *dev)
static int
net_send_packet(struct sk_buff *skb, struct net_device *dev)
{
if (dev->tbusy) {
/* If we get here, some higher level has decided we are broken.
There should really be a "kick me" function call instead. */
int tickssofar = jiffies - dev->trans_start;
if (tickssofar < 5)
return 1;
if (net_debug > 0) printk("%s: transmit timed out, %s?\n", dev->name,
tx_done(dev) ? "IRQ conflict" : "network cable problem");
/* Try to restart the adaptor. */
dev->tbusy=0;
dev->trans_start = jiffies;
}
/* Block a timer-based transmit from overlapping. This could better be
done with atomic_swap(1, dev->tbusy), but set_bit() works as well. */
if (test_and_set_bit(0, (void*)&dev->tbusy) != 0)
printk("%s: Transmitter access conflict.\n", dev->name);
else {
struct net_local *lp = netdev_priv(dev);
unsigned long flags;
......@@ -405,6 +387,7 @@ net_send_packet(struct sk_buff *skb, struct net_device *dev)
ask the chip to start transmitting before the
whole packet has been completely uploaded. */
local_irq_save(flags);
netif_stop_queue(dev);
/* initiate a transmit sequence */
writereg(dev, PP_TxCMD, lp->send_cmd);
......@@ -419,11 +402,11 @@ net_send_packet(struct sk_buff *skb, struct net_device *dev)
}
/* Write the contents of the packet */
memcpy_toio(dev->mem_start + PP_TxFrame, skb->data, skb->len+1);
skb_copy_from_linear_data(skb, (void *)(dev->mem_start + PP_TxFrame),
skb->len+1);
local_irq_restore(flags);
dev->trans_start = jiffies;
}
dev_kfree_skb (skb);
return 0;
......@@ -441,9 +424,6 @@ static irqreturn_t net_interrupt(int irq, void *dev_id)
printk ("net_interrupt(): irq %d for unknown device.\n", irq);
return IRQ_NONE;
}
if (dev->interrupt)
printk("%s: Re-entering the interrupt handler.\n", dev->name);
dev->interrupt = 1;
ioaddr = dev->base_addr;
lp = netdev_priv(dev);
......@@ -464,8 +444,7 @@ static irqreturn_t net_interrupt(int irq, void *dev_id)
break;
case ISQ_TRANSMITTER_EVENT:
lp->stats.tx_packets++;
dev->tbusy = 0;
mark_bh(NET_BH); /* Inform upper layers. */
netif_wake_queue(dev);
if ((status & TX_OK) == 0) lp->stats.tx_errors++;
if (status & TX_LOST_CRS) lp->stats.tx_carrier_errors++;
if (status & TX_SQE_ERROR) lp->stats.tx_heartbeat_errors++;
......@@ -479,8 +458,7 @@ static irqreturn_t net_interrupt(int irq, void *dev_id)
That shouldn't happen since we only ever
load one packet. Shrug. Do the right
thing anyway. */
dev->tbusy = 0;
mark_bh(NET_BH); /* Inform upper layers. */
netif_wake_queue(dev);
}
if (status & TX_UNDERRUN) {
if (net_debug > 0) printk("%s: transmit underrun\n", dev->name);
......@@ -497,7 +475,6 @@ static irqreturn_t net_interrupt(int irq, void *dev_id)
break;
}
}
dev->interrupt = 0;
return IRQ_HANDLED;
}
......@@ -531,7 +508,8 @@ net_rx(struct net_device *dev)
}
skb_put(skb, length);
memcpy_fromio(skb->data, dev->mem_start + PP_RxFrame, length);
skb_copy_to_linear_data(skb, (void *)(dev->mem_start + PP_RxFrame),
length);
if (net_debug > 3)printk("%s: received %d byte packet of type %x\n",
dev->name, length,
......@@ -610,8 +588,6 @@ static void set_multicast_list(struct net_device *dev)
static int set_mac_address(struct net_device *dev, void *addr)
{
int i;
if (dev->start)
return -EBUSY;
printk("%s: Setting MAC address to ", dev->name);
for (i = 0; i < 6; i++)
printk(" %2.2x", dev->dev_addr[i] = ((unsigned char *)addr)[i]);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment