media: omap3isp: Explicitly set the number of CSI-2 lanes used in lane cfg

The omap3isp driver extracts the CSI-2 lane configuration from the V4L2
fwnode endpoint but misses the number of lanes itself. Get this information
and use it in PHY configuration.
Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Tested-by: Pavel Machek <pavel@ucw.cz>
Signed-off-by: Mauro Carvalho Chehab <mchehab@s-opensource.com>

drivers/media/platform/omap3isp/isp.c

@@ -2061,7 +2061,10 @@ static int isp_fwnode_parse(struct device *dev, struct fwnode_handle *fwnode,
 			buscfg->bus.csi2.lanecfg.clk.pol,
 			buscfg->bus.csi2.lanecfg.clk.pos);
 
-		for (i = 0; i < ISP_CSIPHY2_NUM_DATA_LANES; i++) {
+		buscfg->bus.csi2.num_data_lanes =
+			vep.bus.mipi_csi2.num_data_lanes;
+
+		for (i = 0; i < buscfg->bus.csi2.num_data_lanes; i++) {
 			buscfg->bus.csi2.lanecfg.data[i].pos =
 				vep.bus.mipi_csi2.data_lanes[i];
 			buscfg->bus.csi2.lanecfg.data[i].pol =

drivers/media/platform/omap3isp/ispcsiphy.c

@@ -169,7 +169,7 @@ static int omap3isp_csiphy_config(struct isp_csiphy *phy)
 	struct isp_bus_cfg *buscfg = pipe->external->host_priv;
 	struct isp_csiphy_lanes_cfg *lanes;
 	int csi2_ddrclk_khz;
-	unsigned int used_lanes = 0;
+	unsigned int num_data_lanes, used_lanes = 0;
 	unsigned int i;
 	u32 reg;
 
@@ -181,13 +181,19 @@ static int omap3isp_csiphy_config(struct isp_csiphy *phy)
 	}
 
 	if (buscfg->interface == ISP_INTERFACE_CCP2B_PHY1
-	    || buscfg->interface == ISP_INTERFACE_CCP2B_PHY2)
+	    || buscfg->interface == ISP_INTERFACE_CCP2B_PHY2) {
 		lanes = &buscfg->bus.ccp2.lanecfg;
-	else
+		num_data_lanes = 1;
+	} else {
 		lanes = &buscfg->bus.csi2.lanecfg;
+		num_data_lanes = buscfg->bus.csi2.num_data_lanes;
+	}
+
+	if (num_data_lanes > phy->num_data_lanes)
+		return -EINVAL;
 
 	/* Clock and data lanes verification */
-	for (i = 0; i < phy->num_data_lanes; i++) {
+	for (i = 0; i < num_data_lanes; i++) {
 		if (lanes->data[i].pol > 1 || lanes->data[i].pos > 3)
 			return -EINVAL;
 
@@ -243,7 +249,7 @@ static int omap3isp_csiphy_config(struct isp_csiphy *phy)
 	/* DPHY lane configuration */
 	reg = isp_reg_readl(csi2->isp, phy->cfg_regs, ISPCSI2_PHY_CFG);
 
-	for (i = 0; i < phy->num_data_lanes; i++) {
+	for (i = 0; i < num_data_lanes; i++) {
 		reg &= ~(ISPCSI2_PHY_CFG_DATA_POL_MASK(i + 1) |
 			 ISPCSI2_PHY_CFG_DATA_POSITION_MASK(i + 1));
 		reg |= (lanes->data[i].pol <<

drivers/media/platform/omap3isp/omap3isp.h

@@ -114,10 +114,13 @@ struct isp_ccp2_cfg {
 /**
  * struct isp_csi2_cfg - CSI2 interface configuration
  * @crc: Enable the cyclic redundancy check
+ * @lanecfg: CSI-2 lane configuration
+ * @num_data_lanes: The number of data lanes in use
  */
 struct isp_csi2_cfg {
 	unsigned crc:1;
 	struct isp_csiphy_lanes_cfg lanecfg;
+	u8 num_data_lanes;
 };
 
 struct isp_bus_cfg {