Commit 3bd14233 authored by Mark A. Greer's avatar Mark A. Greer Committed by Samuel Ortiz

NFC: trf7970a: Add VIN voltage override support

The trf7970a driver uses the voltage from the
power/regulator subsystem to determine what the
voltage on the VIN pin is.  Normally, this is
the right thing to do but sometimes the board
that the trf7970a is on may change the voltage.
This is the case for the trf7970atb board from
Texas Instruments where it boosts the VIN voltage
from 3.3V to 5V (see http://www.ti.com/tool/trf7970atb).

To handle this, add support for the 'vin-voltage-override'
device tree property which overrides the voltage value
given by the regulator subsystem.  When the DT property
is not present, the value from the regulator subsystem
is used.

The value of 'vin-voltage-override' is in uVolts.
Signed-off-by: default avatarMark A. Greer <mgreer@animalcreek.com>
Signed-off-by: default avatarSamuel Ortiz <sameo@linux.intel.com>
parent dddb3da0
......@@ -1251,6 +1251,12 @@ static int trf7970a_get_autosuspend_delay(struct device_node *np)
return autosuspend_delay;
}
static int trf7970a_get_vin_voltage_override(struct device_node *np,
u32 *vin_uvolts)
{
return of_property_read_u32(np, "vin-voltage-override", vin_uvolts);
}
static int trf7970a_probe(struct spi_device *spi)
{
struct device_node *np = spi->dev.of_node;
......@@ -1326,6 +1332,8 @@ static int trf7970a_probe(struct spi_device *spi)
goto err_destroy_lock;
}
ret = trf7970a_get_vin_voltage_override(np, &uvolts);
if (ret)
uvolts = regulator_get_voltage(trf->regulator);
if (uvolts > 4000000)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment