net: systemport: Only inspect valid switch port & queues

Hesoteric board configurations where port 0 is not available would still
make SYSTEMPORT inspect the switch port 0, queue 0, which, not being
enabled, would cause transmit timeouts over time. Just ignore those
unconfigured rings instead.

Fixes: 84ff33eeb23d ("net: systemport: Establish DSA network device queue mapping")
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/bcmsysport.c

@@ -1420,8 +1420,12 @@ static int bcm_sysport_init_tx_ring(struct bcm_sysport_priv *priv,
 	/* Configure QID and port mapping */
 	reg = tdma_readl(priv, TDMA_DESC_RING_MAPPING(index));
 	reg &= ~(RING_QID_MASK | RING_PORT_ID_MASK << RING_PORT_ID_SHIFT);
+	if (ring->inspect) {
 		reg |= ring->switch_queue & RING_QID_MASK;
 		reg |= ring->switch_port << RING_PORT_ID_SHIFT;
+	} else {
+		reg |= RING_IGNORE_STATUS;
+	}
 	tdma_writel(priv, reg, TDMA_DESC_RING_MAPPING(index));
 	tdma_writel(priv, 0, TDMA_DESC_RING_PCP_DEI_VID(index));
 
@@ -2108,6 +2112,7 @@ static int bcm_sysport_map_queues(struct net_device *dev,
 		 */
 		ring->switch_queue = q;
 		ring->switch_port = port;
+		ring->inspect = true;
 		priv->ring_map[q + port * num_tx_queues] = ring;
 
 		/* Set all queues as being used now */

drivers/net/ethernet/broadcom/bcmsysport.h

@@ -714,6 +714,7 @@ struct bcm_sysport_tx_ring {
 	unsigned long	bytes;		/* bytes statistics */
 	unsigned int	switch_queue;	/* switch port queue number */
 	unsigned int	switch_port;	/* switch port queue number */
+	bool		inspect;	/* inspect switch port and queue */
 };
 
 /* Driver private structure */