Commit 40f7bfe4 authored by Will Deacon's avatar Will Deacon Committed by Russell King

ARM: 6914/1: sparsemem: fix highmem detection when using SPARSEMEM

sanity_check_meminfo walks over the registered memory banks and attempts
to split banks across lowmem and highmem when they would otherwise
overlap with the vmalloc space.

When SPARSEMEM is used, there are two potential problems that occur
when the virtual address of the start of a bank is equal to vmalloc_min.

 1.) The end of lowmem is calculated as __pa(vmalloc_min - 1) + 1.
     In the above scenario, this will give the end address of the
     previous bank, rather than the actual bank we are interested in.
     This value is later used as the memblock limit and artificially
     restricts the total amount of available memory.

 2.) The checks to determine whether or not a bank belongs to highmem
     or not only check if __va(bank->start) is greater or less than
     vmalloc_min. In the case that it is equal, the bank is incorrectly
     treated as lowmem, which hoses the vmalloc area.

This patch fixes these two problems by checking whether the virtual
start address of a bank is >= vmalloc_min and then calculating
lowmem_end by finding the virtual end address of the highest lowmem
bank.
Acked-by: default avatarCatalin Marinas <catalin.marinas@arm.com>
Reviewed-by: default avatarNicolas Pitre <nicolas.pitre@linaro.org>
Signed-off-by: default avatarWill Deacon <will.deacon@arm.com>
Signed-off-by: default avatarRussell King <rmk+kernel@arm.linux.org.uk>
parent 7b7bf499
......@@ -763,15 +763,12 @@ static void __init sanity_check_meminfo(void)
{
int i, j, highmem = 0;
lowmem_limit = __pa(vmalloc_min - 1) + 1;
memblock_set_current_limit(lowmem_limit);
for (i = 0, j = 0; i < meminfo.nr_banks; i++) {
struct membank *bank = &meminfo.bank[j];
*bank = meminfo.bank[i];
#ifdef CONFIG_HIGHMEM
if (__va(bank->start) > vmalloc_min ||
if (__va(bank->start) >= vmalloc_min ||
__va(bank->start) < (void *)PAGE_OFFSET)
highmem = 1;
......@@ -829,6 +826,9 @@ static void __init sanity_check_meminfo(void)
bank->size = newsize;
}
#endif
if (!bank->highmem && bank->start + bank->size > lowmem_limit)
lowmem_limit = bank->start + bank->size;
j++;
}
#ifdef CONFIG_HIGHMEM
......@@ -852,6 +852,7 @@ static void __init sanity_check_meminfo(void)
}
#endif
meminfo.nr_banks = j;
memblock_set_current_limit(lowmem_limit);
}
static inline void prepare_page_table(void)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment