e1000e: write protect ICHx NVM to prevent malicious write/erase

Set the hardware to ignore all write/erase cycles to the GbE region in
the ICHx NVM.  This feature can be disabled by the WriteProtectNVM module
parameter (enabled by default) only after a hardware reset, but
the machine must be power cycled before trying to enable writes.
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com>
CC: arjan@linux.intel.com
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

drivers/net/e1000e/e1000.h

@@ -305,6 +305,7 @@ struct e1000_info {
 #define FLAG_HAS_CTRLEXT_ON_LOAD          (1 << 5)
 #define FLAG_HAS_SWSM_ON_LOAD             (1 << 6)
 #define FLAG_HAS_JUMBO_FRAMES             (1 << 7)
+#define FLAG_READ_ONLY_NVM                (1 << 8)
 #define FLAG_IS_ICH                       (1 << 9)
 #define FLAG_HAS_SMART_POWER_DOWN         (1 << 11)
 #define FLAG_IS_QUAD_PORT_A               (1 << 12)
@@ -385,6 +386,7 @@ extern bool e1000e_enable_mng_pass_thru(struct e1000_hw *hw);
 extern bool e1000e_get_laa_state_82571(struct e1000_hw *hw);
 extern void e1000e_set_laa_state_82571(struct e1000_hw *hw, bool state);
 
+extern void e1000e_write_protect_nvm_ich8lan(struct e1000_hw *hw);
 extern void e1000e_set_kmrn_lock_loss_workaround_ich8lan(struct e1000_hw *hw,
 						 bool state);
 extern void e1000e_igp3_phy_powerdown_workaround_ich8lan(struct e1000_hw *hw);

drivers/net/e1000e/ethtool.c

@@ -529,6 +529,9 @@ static int e1000_set_eeprom(struct net_device *netdev,
 	if (eeprom->magic != (adapter->pdev->vendor | (adapter->pdev->device << 16)))
 		return -EFAULT;
 
+	if (adapter->flags & FLAG_READ_ONLY_NVM)
+		return -EINVAL;
+
 	max_len = hw->nvm.word_size * 2;
 
 	first_word = eeprom->offset >> 1;

drivers/net/e1000e/ich8lan.c

@@ -58,6 +58,7 @@
 #define ICH_FLASH_HSFCTL		0x0006
 #define ICH_FLASH_FADDR			0x0008
 #define ICH_FLASH_FDATA0		0x0010
+#define ICH_FLASH_PR0			0x0074
 
 #define ICH_FLASH_READ_COMMAND_TIMEOUT	500
 #define ICH_FLASH_WRITE_COMMAND_TIMEOUT	500
@@ -150,6 +151,19 @@ union ich8_hws_flash_regacc {
 	u16 regval;
 };
 
+/* ICH Flash Protected Region */
+union ich8_flash_protected_range {
+	struct ich8_pr {
+		u32 base:13;     /* 0:12 Protected Range Base */
+		u32 reserved1:2; /* 13:14 Reserved */
+		u32 rpe:1;       /* 15 Read Protection Enable */
+		u32 limit:13;    /* 16:28 Protected Range Limit */
+		u32 reserved2:2; /* 29:30 Reserved */
+		u32 wpe:1;       /* 31 Write Protection Enable */
+	} range;
+	u32 regval;
+};
+
 static s32 e1000_setup_link_ich8lan(struct e1000_hw *hw);
 static void e1000_clear_hw_cntrs_ich8lan(struct e1000_hw *hw);
 static void e1000_initialize_hw_bits_ich8lan(struct e1000_hw *hw);
@@ -1284,6 +1298,7 @@ static s32 e1000_update_nvm_checksum_ich8lan(struct e1000_hw *hw)
 	 * programming failed.
 	 */
 	if (ret_val) {
+		/* Possibly read-only, see e1000e_write_protect_nvm_ich8lan() */
 		hw_dbg(hw, "Flash commit failed.\n");
 		e1000_release_swflag_ich8lan(hw);
 		return ret_val;
@@ -1373,6 +1388,49 @@ static s32 e1000_validate_nvm_checksum_ich8lan(struct e1000_hw *hw)
 	return e1000e_validate_nvm_checksum_generic(hw);
 }
 
+/**
+ *  e1000e_write_protect_nvm_ich8lan - Make the NVM read-only
+ *  @hw: pointer to the HW structure
+ *
+ *  To prevent malicious write/erase of the NVM, set it to be read-only
+ *  so that the hardware ignores all write/erase cycles of the NVM via
+ *  the flash control registers.  The shadow-ram copy of the NVM will
+ *  still be updated, however any updates to this copy will not stick
+ *  across driver reloads.
+ **/
+void e1000e_write_protect_nvm_ich8lan(struct e1000_hw *hw)
+{
+	union ich8_flash_protected_range pr0;
+	union ich8_hws_flash_status hsfsts;
+	u32 gfpreg;
+	s32 ret_val;
+
+	ret_val = e1000_acquire_swflag_ich8lan(hw);
+	if (ret_val)
+		return;
+
+	gfpreg = er32flash(ICH_FLASH_GFPREG);
+
+	/* Write-protect GbE Sector of NVM */
+	pr0.regval = er32flash(ICH_FLASH_PR0);
+	pr0.range.base = gfpreg & FLASH_GFPREG_BASE_MASK;
+	pr0.range.limit = ((gfpreg >> 16) & FLASH_GFPREG_BASE_MASK);
+	pr0.range.wpe = true;
+	ew32flash(ICH_FLASH_PR0, pr0.regval);
+
+	/*
+	 * Lock down a subset of GbE Flash Control Registers, e.g.
+	 * PR0 to prevent the write-protection from being lifted.
+	 * Once FLOCKDN is set, the registers protected by it cannot
+	 * be written until FLOCKDN is cleared by a hardware reset.
+	 */
+	hsfsts.regval = er16flash(ICH_FLASH_HSFSTS);
+	hsfsts.hsf_status.flockdn = true;
+	ew32flash(ICH_FLASH_HSFSTS, hsfsts.regval);
+
+	e1000_release_swflag_ich8lan(hw);
+}
+
 /**
  *  e1000_write_flash_data_ich8lan - Writes bytes to the NVM
  *  @hw: pointer to the HW structure

drivers/net/e1000e/netdev.c

@@ -47,7 +47,7 @@
 
 #include "e1000.h"
 
-#define DRV_VERSION "0.3.3.3-k2"
+#define DRV_VERSION "0.3.3.3-k4"
 char e1000e_driver_name[] = "e1000e";
 const char e1000e_driver_version[] = DRV_VERSION;
 
@@ -4467,6 +4467,8 @@ static int __devinit e1000_probe(struct pci_dev *pdev,
 
 	adapter->bd_number = cards_found++;
 
+	e1000e_check_options(adapter);
+
 	/* setup adapter struct */
 	err = e1000_sw_init(adapter);
 	if (err)
@@ -4482,6 +4484,10 @@ static int __devinit e1000_probe(struct pci_dev *pdev,
 	if (err)
 		goto err_hw_init;
 
+	if ((adapter->flags & FLAG_IS_ICH) &&
+	    (adapter->flags & FLAG_READ_ONLY_NVM))
+		e1000e_write_protect_nvm_ich8lan(&adapter->hw);
+
 	hw->mac.ops.get_bus_info(&adapter->hw);
 
 	adapter->hw.phy.autoneg_wait_to_complete = 0;
@@ -4573,8 +4579,6 @@ static int __devinit e1000_probe(struct pci_dev *pdev,
 	INIT_WORK(&adapter->reset_task, e1000_reset_task);
 	INIT_WORK(&adapter->watchdog_task, e1000_watchdog_task);
 
-	e1000e_check_options(adapter);
-
 	/* Initialize link parameters. User can change them with ethtool */
 	adapter->hw.mac.autoneg = 1;
 	adapter->fc_autoneg = 1;

drivers/net/e1000e/param.c

@@ -133,6 +133,15 @@ E1000_PARAM(SmartPowerDownEnable, "Enable PHY smart power down");
  */
 E1000_PARAM(KumeranLockLoss, "Enable Kumeran lock loss workaround");
 
+/*
+ * Write Protect NVM
+ *
+ * Valid Range: 0, 1
+ *
+ * Default Value: 1 (enabled)
+ */
+E1000_PARAM(WriteProtectNVM, "Write-protect NVM [WARNING: disabling this can lead to corrupted NVM]");
+
 struct e1000_option {
 	enum { enable_option, range_option, list_option } type;
 	const char *name;
@@ -388,4 +397,25 @@ void __devinit e1000e_check_options(struct e1000_adapter *adapter)
 								       opt.def);
 		}
 	}
+	{ /* Write-protect NVM */
+		const struct e1000_option opt = {
+			.type = enable_option,
+			.name = "Write-protect NVM",
+			.err  = "defaulting to Enabled",
+			.def  = OPTION_ENABLED
+		};
+
+		if (adapter->flags & FLAG_IS_ICH) {
+			if (num_WriteProtectNVM > bd) {
+				unsigned int write_protect_nvm = WriteProtectNVM[bd];
+				e1000_validate_option(&write_protect_nvm, &opt,
+						      adapter);
+				if (write_protect_nvm)
+					adapter->flags |= FLAG_READ_ONLY_NVM;
+			} else {
+				if (opt.def)
+					adapter->flags |= FLAG_READ_ONLY_NVM;
+			}
+		}
+	}
 }