Commit 61c2a80b authored by Grazvydas Ignotas's avatar Grazvydas Ignotas Committed by John W. Linville

wl1251: read default MAC address from EEPROM when available

Some wl1251 hardware configurations (like in WG7210 module) have
EEPROM attached where NVS data is kept, which includes MAC address.

In such configurations, let's read default MAC address from EEPROM,
instead of using random one.
Signed-off-by: default avatarGrazvydas Ignotas <notasas@gmail.com>
Acked-by: default avatarKalle Valo <kvalo@adurom.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent a5e944f1
......@@ -1195,6 +1195,66 @@ static const struct ieee80211_ops wl1251_ops = {
.conf_tx = wl1251_op_conf_tx,
};
static int wl1251_read_eeprom_byte(struct wl1251 *wl, off_t offset, u8 *data)
{
unsigned long timeout;
wl1251_reg_write32(wl, EE_ADDR, offset);
wl1251_reg_write32(wl, EE_CTL, EE_CTL_READ);
/* EE_CTL_READ clears when data is ready */
timeout = jiffies + msecs_to_jiffies(100);
while (1) {
if (!(wl1251_reg_read32(wl, EE_CTL) & EE_CTL_READ))
break;
if (time_after(jiffies, timeout))
return -ETIMEDOUT;
msleep(1);
}
*data = wl1251_reg_read32(wl, EE_DATA);
return 0;
}
static int wl1251_read_eeprom(struct wl1251 *wl, off_t offset,
u8 *data, size_t len)
{
size_t i;
int ret;
wl1251_reg_write32(wl, EE_START, 0);
for (i = 0; i < len; i++) {
ret = wl1251_read_eeprom_byte(wl, offset + i, &data[i]);
if (ret < 0)
return ret;
}
return 0;
}
static int wl1251_read_eeprom_mac(struct wl1251 *wl)
{
u8 mac[ETH_ALEN];
int i, ret;
wl1251_set_partition(wl, 0, 0, REGISTERS_BASE, REGISTERS_DOWN_SIZE);
ret = wl1251_read_eeprom(wl, 0x1c, mac, sizeof(mac));
if (ret < 0) {
wl1251_warning("failed to read MAC address from EEPROM");
return ret;
}
/* MAC is stored in reverse order */
for (i = 0; i < ETH_ALEN; i++)
wl->mac_addr[i] = mac[ETH_ALEN - i - 1];
return 0;
}
static int wl1251_register_hw(struct wl1251 *wl)
{
int ret;
......@@ -1241,6 +1301,9 @@ int wl1251_init_ieee80211(struct wl1251 *wl)
wl->hw->queues = 4;
if (wl->use_eeprom)
wl1251_read_eeprom_mac(wl);
ret = wl1251_register_hw(wl);
if (ret)
goto out;
......
......@@ -46,7 +46,14 @@
#define SOR_CFG (REGISTERS_BASE + 0x0800)
#define ECPU_CTRL (REGISTERS_BASE + 0x0804)
#define HI_CFG (REGISTERS_BASE + 0x0808)
/* EEPROM registers */
#define EE_START (REGISTERS_BASE + 0x080C)
#define EE_CTL (REGISTERS_BASE + 0x2000)
#define EE_DATA (REGISTERS_BASE + 0x2004)
#define EE_ADDR (REGISTERS_BASE + 0x2008)
#define EE_CTL_READ 2
#define CHIP_ID_B (REGISTERS_BASE + 0x5674)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment