Merge branch 'mlxsw-Two-small-fixes'

Ido Schimmel says:

====================
mlxsw: Two small fixes

Patch #1 from Jiri fixes an issue specific to Spectrum-2 where the
insertion of two identical flower filters with different priorities
would trigger a warning.

Patch #2 from Amit prevents the driver from trying to configure a port
with a speed of 56Gb/s and autoneg off as this is not supported and
results in error messages from firmware.

Please consider patch #1 for stable.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/mellanox/mlxsw/spectrum.c

@@ -3128,6 +3128,10 @@ mlxsw_sp_port_set_link_ksettings(struct net_device *dev,
 	ops->reg_ptys_eth_unpack(mlxsw_sp, ptys_pl, &eth_proto_cap, NULL, NULL);
 
 	autoneg = cmd->base.autoneg == AUTONEG_ENABLE;
+	if (!autoneg && cmd->base.speed == SPEED_56000) {
+		netdev_err(dev, "56G not supported with autoneg off\n");
+		return -EINVAL;
+	}
 	eth_proto_new = autoneg ?
 		ops->to_ptys_advert_link(mlxsw_sp, cmd) :
 		ops->to_ptys_speed(mlxsw_sp, cmd->base.speed);

drivers/net/ethernet/mellanox/mlxsw/spectrum_acl_erp.c

@@ -1171,13 +1171,12 @@ mlxsw_sp_acl_erp_delta_fill(const struct mlxsw_sp_acl_erp_key *parent_key,
 			return -EINVAL;
 	}
 	if (si == -1) {
-		/* The masks are the same, this cannot happen.
-		 * That means the caller is broken.
+		/* The masks are the same, this can happen in case eRPs with
+		 * the same mask were created in both A-TCAM and C-TCAM.
+		 * The only possible condition under which this can happen
+		 * is identical rule insertion. Delta is not possible here.
 		 */
-		WARN_ON(1);
-		*delta_start = 0;
-		*delta_mask = 0;
-		return 0;
+		return -EINVAL;
 	}
 	pmask = (unsigned char) parent_key->mask[__MASK_IDX(si)];
 	mask = (unsigned char) key->mask[__MASK_IDX(si)];