Commit 693828fe authored by Rajkumar Manoharan's avatar Rajkumar Manoharan Committed by John W. Linville

mac80211: stop tx before doing hw config and rate update

The assumption is that during the hw config, transmission was
already stopped by mac80211. Sometimes the AP can be switching
b/w the ht modes due to intolerant or etc where STA is in
the middle of transmission. In such scenario, buffer overflow
was observed at driver side. And also before updating the rate
control, the frames are continued to xmited with older rates.
This patch ensures that the frames are always xmitted with
updated rates and avoid buffer overflow.
Signed-off-by: default avatarRajkumar Manoharan <rmanohar@qca.qualcomm.com>
Reviewed-by: default avatarJohannes Berg <johannes@sipsolutions.net>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent c9c0d9ec
......@@ -671,6 +671,7 @@ enum queue_stop_reason {
IEEE80211_QUEUE_STOP_REASON_AGGREGATION,
IEEE80211_QUEUE_STOP_REASON_SUSPEND,
IEEE80211_QUEUE_STOP_REASON_SKB_ADD,
IEEE80211_QUEUE_STOP_REASON_CHTYPE_CHANGE,
};
#ifdef CONFIG_MAC80211_LEDS
......
......@@ -1918,8 +1918,24 @@ static void ieee80211_rx_mgmt_beacon(struct ieee80211_sub_if_data *sdata,
rcu_read_unlock();
/*
* Whenever the AP announces the HT mode change that can be
* 40MHz intolerant or etc., it would be safer to stop tx
* queues before doing hw config to avoid buffer overflow.
*/
ieee80211_stop_queues_by_reason(&sdata->local->hw,
IEEE80211_QUEUE_STOP_REASON_CHTYPE_CHANGE);
/* flush out all packets */
synchronize_net();
drv_flush(local, false);
changed |= ieee80211_enable_ht(sdata, elems.ht_info_elem,
bssid, ap_ht_cap_flags);
ieee80211_wake_queues_by_reason(&sdata->local->hw,
IEEE80211_QUEUE_STOP_REASON_CHTYPE_CHANGE);
}
/* Note: country IE parsing is done for us by cfg80211 */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment