iwlwifi: mvm: Add and examine TLV flag for P2P client uAPSD support

Current firmware doesn't handle well uAPSD in P2P Client.
When it will be fixed, the firmware will set a TLV flag to notify
the driver that uAPSD is supported in P2P client mode.
Check this flag when sending power command for P2P client.
Signed-off-by: Alexander Bondar <alexander.bondar@intel.com>
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>

drivers/net/wireless/iwlwifi/iwl-fw.h

@@ -94,6 +94,7 @@
  *	containing CAM (Continuous Active Mode) indication.
  * @IWL_UCODE_TLV_FLAGS_P2P_PS: P2P client power save is supported (only on a
  *	single bound interface).
+ * @IWL_UCODE_TLV_FLAGS_P2P_PS_UAPSD: P2P client supports uAPSD power save
  */
 enum iwl_ucode_tlv_flag {
 	IWL_UCODE_TLV_FLAGS_PAN			= BIT(0),
@@ -117,6 +118,7 @@ enum iwl_ucode_tlv_flag {
 	IWL_UCODE_TLV_FLAGS_DEVICE_PS_CMD	= BIT(20),
 	IWL_UCODE_TLV_FLAGS_P2P_PS		= BIT(21),
 	IWL_UCODE_TLV_FLAGS_UAPSD_SUPPORT	= BIT(24),
+	IWL_UCODE_TLV_FLAGS_P2P_PS_UAPSD	= BIT(26),
 };
 
 /* The default calibrate table size if not specified by firmware file */

drivers/net/wireless/iwlwifi/mvm/power.c

@@ -358,6 +358,10 @@ static void iwl_mvm_power_build_cmd(struct iwl_mvm *mvm,
 	if (!memcmp(mvmvif->uapsd_misbehaving_bssid, vif->bss_conf.bssid,
 		    ETH_ALEN))
 		allow_uapsd = false;
+
+	if (vif->p2p &&
+	    !(mvm->fw->ucode_capa.flags & IWL_UCODE_TLV_FLAGS_P2P_PS_UAPSD))
+		allow_uapsd = false;
 	/*
 	 * Avoid using uAPSD if P2P client is associated to GO that uses
 	 * opportunistic power save. This is due to current FW limitation.