Commit 8558c6e2 authored by Andreas Kemnade's avatar Andreas Kemnade Committed by Maxime Ripard

ARM: dts: sun8i: h3: bluetooth for Banana Pi M2 Zero board

The Banana Pi M2 Zero board has an AP6212 BT+Wifi combo chip
with Broadcom internals attached to UART1 and some gpios.
This addition is in line with similar boards.
Signed-off-by: default avatarAndreas Kemnade <andreas@kemnade.info>
Signed-off-by: default avatarMaxime Ripard <maxime.ripard@bootlin.com>
parent 88a20add
...@@ -66,6 +66,8 @@ reg_vdd_cpux: vdd-cpux-regulator { ...@@ -66,6 +66,8 @@ reg_vdd_cpux: vdd-cpux-regulator {
wifi_pwrseq: wifi_pwrseq { wifi_pwrseq: wifi_pwrseq {
compatible = "mmc-pwrseq-simple"; compatible = "mmc-pwrseq-simple";
reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */ reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */
clocks = <&rtc 1>;
clock-names = "ext_clock";
}; };
}; };
...@@ -119,7 +121,20 @@ &uart0 { ...@@ -119,7 +121,20 @@ &uart0 {
&uart1 { &uart1 {
pinctrl-names = "default"; pinctrl-names = "default";
pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>; pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
uart-has-rtscts;
status = "okay"; status = "okay";
bluetooth {
compatible = "brcm,bcm43438-bt";
clocks = <&rtc 1>;
clock-names = "lpo";
vbat-supply = <&reg_vcc3v3>;
vddio-supply = <&reg_vcc3v3>;
device-wakeup-gpios = <&pio 6 13 GPIO_ACTIVE_HIGH>; /* PG13 */
host-wakeup-gpios = <&pio 6 11 GPIO_ACTIVE_HIGH>; /* PG11 */
shutdown-gpios = <&pio 6 12 GPIO_ACTIVE_HIGH>; /* PG12 */
};
}; };
&usb_otg { &usb_otg {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment