edac: e752x fsb ecc

FSB parity is only supported on the Xeon processor.  Previously it was
incorrectly enabled for the Celeron as well.
Signed-off-by: Konstantin Olifer <kolifer@gmail.com>
Signed-off-by: Doug Thompson <dougthompson@xmission.com>
Cc: Peter Tyser <ptyser@xes-inc.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

drivers/edac/e752x_edac.c

@@ -1074,9 +1074,6 @@ static int e752x_get_devs(struct pci_dev *pdev, int dev_idx,
 /* Setup system bus parity mask register.
  * Sysbus parity supported on:
  * e7320/e7520/e7525 + Xeon
- *   i3100 + Xeon/Celeron
- * Sysbus parity not supported on:
- *   i3100 + Pentium M/Celeron M/Core Duo/Core2 Duo
  */
 static void e752x_init_sysbus_parity_mask(struct e752x_pvt *pvt)
 {
@@ -1087,10 +1084,7 @@ static void e752x_init_sysbus_parity_mask(struct e752x_pvt *pvt)
 	/* Allow module parameter override, else see if CPU supports parity */
 	if (sysbus_parity != -1) {
 		enable = sysbus_parity;
-	} else if (cpu_id[0] &&
-		   ((strstr(cpu_id, "Pentium") && strstr(cpu_id, " M ")) ||
-		    (strstr(cpu_id, "Celeron") && strstr(cpu_id, " M ")) ||
-		    (strstr(cpu_id, "Core") && strstr(cpu_id, "Duo")))) {
+	} else if (cpu_id[0] && !strstr(cpu_id, "Xeon")) {
 		e752x_printk(KERN_INFO, "System Bus Parity not "
 			     "supported by CPU, disabling\n");
 		enable = 0;