Commit 92e015cb authored by Márton Németh's avatar Márton Németh Committed by Richard Purdie

leds: hw acceleration for Clevo mail LED driver

Add support for hardware accelerated LED blinking for the mail LED
commonly found on Clevo notebooks.
Signed-off-by: default avatarMárton Németh <nm127@freemail.hu>
Signed-off-by: default avatarRichard Purdie <rpurdie@rpsys.net>
parent 4c79141d
......@@ -122,9 +122,11 @@ config LEDS_CLEVO_MAIL
programs through the leds subsystem. This LED have three
known mode: off, blink at 0.5Hz and blink at 1Hz.
As this LED cannot change it's brightness it blinks instead.
The brightness value 0 means off, 1..127 means blink at 0.5Hz
and 128..255 means blink at 1Hz.
The driver supports two kinds of interface: using ledtrig-timer
or through /sys/class/leds/clevo::mail/brightness. As this LED
cannot change it's brightness it blinks instead. The brightness
value 0 means off, 1..127 means blink at 0.5Hz and 128..255 means
blink at 1Hz.
This module can drive the mail LED for the following notebooks:
......
......@@ -92,9 +92,46 @@ static void clevo_mail_led_set(struct led_classdev *led_cdev,
}
static int clevo_mail_led_blink(struct led_classdev *led_cdev,
unsigned long* delay_on,
unsigned long* delay_off)
{
int status = -EINVAL;
if (*delay_on == 0 /* ms */ && *delay_off == 0 /* ms */) {
/* Special case: the leds subsystem requested us to
* chose one user friendly blinking of the LED, and
* start it. Let's blink the led slowly (0.5Hz).
*/
*delay_on = 1000; /* ms */
*delay_off = 1000; /* ms */
i8042_command(NULL, CLEVO_MAIL_LED_BLINK_0_5HZ);
status = 0;
} else if (*delay_on == 500 /* ms */ && *delay_off == 500 /* ms */) {
/* blink the led with 1Hz */
i8042_command(NULL, CLEVO_MAIL_LED_BLINK_1HZ);
status = 0;
} else if (*delay_on == 1000 /* ms */ && *delay_off == 1000 /* ms */) {
/* blink the led with 0.5Hz */
i8042_command(NULL, CLEVO_MAIL_LED_BLINK_0_5HZ);
status = 0;
} else {
printk(KERN_DEBUG KBUILD_MODNAME
": clevo_mail_led_blink(..., %lu, %lu),"
" returning -EINVAL (unsupported)\n",
*delay_on, *delay_off);
}
return status;
}
static struct led_classdev clevo_mail_led = {
.name = "clevo::mail",
.brightness_set = clevo_mail_led_set,
.blink_set = clevo_mail_led_blink,
};
static int __init clevo_mail_led_probe(struct platform_device *pdev)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment