mm: vmscan: reclaim writepage is IO cost
The VM tries to balance reclaim pressure between anon and file so as to reduce the amount of IO incurred due to the memory shortage. It already counts refaults and swapins, but in addition it should also count writepage calls during reclaim. For swap, this is obvious: it's IO that wouldn't have occurred if the anonymous memory hadn't been under memory pressure. From a relative balancing point of view this makes sense as well: even if anon is cold and reclaimable, a cache that isn't thrashing may have equally cold pages that don't require IO to reclaim. For file writeback, it's trickier: some of the reclaim writepage IO would have likely occurred anyway due to dirty expiration. But not all of it - premature writeback reduces batching and generates additional writes. Since the flushers are already woken up by the time the VM starts writing cache pages one by one, let's assume that we'e likely causing writes that wouldn't have happened without memory pressure. In addition, the per-page cost of IO would have probably been much cheaper if written in larger batches from the flusher thread rather than the single-page-writes from kswapd. For our purposes - getting the trend right to accelerate convergence on a stable state that doesn't require paging at all - this is sufficiently accurate. If we later wanted to optimize for sustained thrashing, we can still refine the measurements. Count all writepage calls from kswapd as IO cost toward the LRU that the page belongs to. Why do this dynamically? Don't we know in advance that anon pages require IO to reclaim, and so could build in a static bias? First, scanning is not the same as reclaiming. If all the anon pages are referenced, we may not swap for a while just because we're scanning the anon list. During this time, however, it's important that we age anonymous memory and the page cache at the same rate so that their hot-cold gradients are comparable. Everything else being equal, we still want to reclaim the coldest memory overall. Second, we keep copies in swap unless the page changes. If there is swap-backed data that's mostly read (tmpfs file) and has been swapped out before, we can reclaim it without incurring additional IO. Signed-off-by: Johannes Weiner <hannes@cmpxchg.org> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Cc: Joonsoo Kim <iamjoonsoo.kim@lge.com> Cc: Michal Hocko <mhocko@suse.com> Cc: Minchan Kim <minchan@kernel.org> Cc: Rik van Riel <riel@surriel.com> Link: http://lkml.kernel.org/r/20200520232525.798933-14-hannes@cmpxchg.orgSigned-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Showing
Please register or sign in to comment