e1000e: do not resume device from RPM suspend to read PHY status registers

When the device is runtime suspended (e.g. when there is no link), do not
wake it from D3 to read the PHY status; just set the values to typical
power-on defaults as is done when runtime PM is not enabled and there is no
link.
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/e1000e/netdev.c

@@ -4684,11 +4684,11 @@ static void e1000_phy_read_status(struct e1000_adapter *adapter)
 	struct e1000_hw *hw = &adapter->hw;
 	struct e1000_phy_regs *phy = &adapter->phy_regs;
 
-	if ((er32(STATUS) & E1000_STATUS_LU) &&
+	if (!pm_runtime_suspended((&adapter->pdev->dev)->parent) &&
+	    (er32(STATUS) & E1000_STATUS_LU) &&
 	    (adapter->hw.phy.media_type == e1000_media_type_copper)) {
 		int ret_val;
 
-		pm_runtime_get_sync(&adapter->pdev->dev);
 		ret_val = e1e_rphy(hw, MII_BMCR, &phy->bmcr);
 		ret_val |= e1e_rphy(hw, MII_BMSR, &phy->bmsr);
 		ret_val |= e1e_rphy(hw, MII_ADVERTISE, &phy->advertise);
@@ -4699,7 +4699,6 @@ static void e1000_phy_read_status(struct e1000_adapter *adapter)
 		ret_val |= e1e_rphy(hw, MII_ESTATUS, &phy->estatus);
 		if (ret_val)
 			e_warn("Error reading PHY register\n");
-		pm_runtime_put_sync(&adapter->pdev->dev);
 	} else {
 		/* Do not read PHY registers if link is not up
 		 * Set values to typical power-on defaults