MXC iomux-v3: Fix defines for PAD_CTL registers

The old defines leaked in from an old version of the patch.
Change the defines to match the register layout of the iomuxer.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

arch/arm/plat-mxc/include/mach/iomux-v3.h

@@ -68,28 +68,24 @@ struct pad_desc {
 /*
  * Use to set PAD control
  */
-#define PAD_CTL_DRIVE_VOLTAGE_3_3_V	0
-#define PAD_CTL_DRIVE_VOLTAGE_1_8_V	1
 
-#define PAD_CTL_NO_HYSTERESIS		0
-#define PAD_CTL_HYSTERESIS		1
+#define PAD_CTL_DVS			(1 << 13)
+#define PAD_CTL_HYS			(1 << 8)
 
-#define PAD_CTL_PULL_DISABLED		0x0
-#define PAD_CTL_PULL_KEEPER		0xa
-#define PAD_CTL_PULL_DOWN_100K		0xc
-#define PAD_CTL_PULL_UP_47K		0xd
-#define PAD_CTL_PULL_UP_100K		0xe
-#define PAD_CTL_PULL_UP_22K		0xf
+#define PAD_CTL_PKE			(1 << 7)
+#define PAD_CTL_PUE			(1 << 6)
+#define PAD_CTL_PUS_100K_DOWN		(0 << 4)
+#define PAD_CTL_PUS_47K_UP		(1 << 4)
+#define PAD_CTL_PUS_100K_UP		(2 << 4)
+#define PAD_CTL_PUS_22K_UP		(3 << 4)
 
-#define PAD_CTL_OUTPUT_CMOS		0
-#define PAD_CTL_OUTPUT_OPEN_DRAIN	1
+#define PAD_CTL_ODE			(1 << 3)
 
-#define PAD_CTL_DRIVE_STRENGTH_NORM	0
-#define PAD_CTL_DRIVE_STRENGTH_HIGH	1
-#define PAD_CTL_DRIVE_STRENGTH_MAX	2
+#define PAD_CTL_DSE_STANDARD		(0 << 1)
+#define PAD_CTL_DSE_HIGH		(1 << 1)
+#define PAD_CTL_DSE_MAX			(2 << 1)
 
-#define PAD_CTL_SLEW_RATE_SLOW		0
-#define PAD_CTL_SLEW_RATE_FAST		1
+#define PAD_CTL_SRE_FAST		(1 << 0)
 
 /*
  * setups a single pad: