Bluetooth: Depend on rather than select GPIOLIB

Commit 27378f4c ("Bluetooth: Avoid WARN splat due to missing
GPIOLIB") amended Kconfig to select GPIOLIB if BT_HCIUART_NOKIA,
BT_HCIUART_INTEL or BT_HCIUART_BCM is enabled since all three drivers
require it to function.

The diagnosis was correct but the treatment was not.  As stated in
Documentation/gpio/consumer.txt:

    Guidelines for GPIOs consumers
    ==============================

    Drivers that can't work without standard GPIO calls should have
    Kconfig entries that depend on GPIOLIB.
                         ^^^^^^^^^
Fix it.
Reported-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Lukas Wunner <lukas@wunner.de>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>

drivers/bluetooth/Kconfig

@@ -108,10 +108,10 @@ config BT_HCIUART_NOKIA
 	tristate "UART Nokia H4+ protocol support"
 	depends on BT_HCIUART
 	depends on BT_HCIUART_SERDEV
+	depends on GPIOLIB
 	depends on PM
 	select BT_HCIUART_H4
 	select BT_BCM
-	select GPIOLIB
 	help
 	  Nokia H4+ is serial protocol for communication between Bluetooth
 	  device and host. This protocol is required for Bluetooth devices
@@ -170,9 +170,9 @@ config BT_HCIUART_3WIRE
 config BT_HCIUART_INTEL
 	bool "Intel protocol support"
 	depends on BT_HCIUART
+	depends on GPIOLIB
 	select BT_HCIUART_H4
 	select BT_INTEL
-	select GPIOLIB
 	help
 	  The Intel protocol support enables Bluetooth HCI over serial
 	  port interface for Intel Bluetooth controllers.
@@ -184,9 +184,9 @@ config BT_HCIUART_BCM
 	depends on BT_HCIUART
 	depends on BT_HCIUART_SERDEV
 	depends on (!ACPI || SERIAL_DEV_CTRL_TTYPORT)
+	depends on GPIOLIB
 	select BT_HCIUART_H4
 	select BT_BCM
-	select GPIOLIB
 	help
 	  The Broadcom protocol support enables Bluetooth HCI over serial
 	  port interface for Broadcom Bluetooth controllers.