Commit a5362b84 authored by Tomer Maimon's avatar Tomer Maimon Committed by Mark Brown

dt-binding: spi: add NPCM PSPI reset binding

Add NPCM Peripheral SPI reset binding documentation,
Removing unnecessary aliases use.
Signed-off-by: default avatarTomer Maimon <tmaimon77@gmail.com>
Acked-by: default avatarRob Herring <robh@kernel.org>
Link: https://lore.kernel.org/r/20200115162301.235926-4-tmaimon77@gmail.comSigned-off-by: default avatarMark Brown <broonie@kernel.org>
parent b5df0b2e
...@@ -12,6 +12,7 @@ Required properties: ...@@ -12,6 +12,7 @@ Required properties:
- clock-names: Should be "clk_apb5". - clock-names: Should be "clk_apb5".
- pinctrl-names : a pinctrl state named "default" must be defined. - pinctrl-names : a pinctrl state named "default" must be defined.
- pinctrl-0 : phandle referencing pin configuration of the device. - pinctrl-0 : phandle referencing pin configuration of the device.
- resets : phandle to the reset control for this device.
- cs-gpios: Specifies the gpio pins to be used for chipselects. - cs-gpios: Specifies the gpio pins to be used for chipselects.
See: Documentation/devicetree/bindings/spi/spi-bus.txt See: Documentation/devicetree/bindings/spi/spi-bus.txt
...@@ -19,16 +20,6 @@ Optional properties: ...@@ -19,16 +20,6 @@ Optional properties:
- clock-frequency : Input clock frequency to the PSPI block in Hz. - clock-frequency : Input clock frequency to the PSPI block in Hz.
Default is 25000000 Hz. Default is 25000000 Hz.
Aliases:
- All the SPI controller nodes should be represented in the aliases node using
the following format 'spi{n}' withe the correct numbered in "aliases" node.
Example:
aliases {
spi0 = &spi0;
};
spi0: spi@f0200000 { spi0: spi@f0200000 {
compatible = "nuvoton,npcm750-pspi"; compatible = "nuvoton,npcm750-pspi";
reg = <0xf0200000 0x1000>; reg = <0xf0200000 0x1000>;
...@@ -39,5 +30,6 @@ spi0: spi@f0200000 { ...@@ -39,5 +30,6 @@ spi0: spi@f0200000 {
interrupts = <GIC_SPI 31 IRQ_TYPE_LEVEL_HIGH>; interrupts = <GIC_SPI 31 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&clk NPCM7XX_CLK_APB5>; clocks = <&clk NPCM7XX_CLK_APB5>;
clock-names = "clk_apb5"; clock-names = "clk_apb5";
resets = <&rstc NPCM7XX_RESET_IPSRST2 NPCM7XX_RESET_PSPI1>
cs-gpios = <&gpio6 11 GPIO_ACTIVE_LOW>; cs-gpios = <&gpio6 11 GPIO_ACTIVE_LOW>;
}; };
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment