phy: omap-usb2-phy: disable PHY charger detect

AM654x PG1.0 has a silicon bug that D+ is pulled high after POR, which
could cause enumeration failure with some USB hubs.  Disabling the
USB2_PHY Charger Detect function will put D+ into the normal state.

This addresses Silicon Errata:
i2075 - "USB2PHY: USB2PHY Charger Detect is Enabled by Default Without VBUS
Presence"
Signed-off-by: Roger Quadros <rogerq@ti.com>
Tested-by: Jan Kiszka <jan.kiszka@siemens.com>
Link: https://lore.kernel.org/r/20200824075127.14902-2-rogerq@ti.comSigned-off-by: Vinod Koul <vkoul@kernel.org>

drivers/phy/ti/phy-omap-usb2.c

@@ -22,10 +22,15 @@
 #include <linux/mfd/syscon.h>
 #include <linux/regmap.h>
 #include <linux/of_platform.h>
+#include <linux/sys_soc.h>
 
 #define USB2PHY_ANA_CONFIG1		0x4c
 #define USB2PHY_DISCON_BYP_LATCH	BIT(31)
 
+#define USB2PHY_CHRG_DET			0x14
+#define USB2PHY_CHRG_DET_USE_CHG_DET_REG	BIT(29)
+#define USB2PHY_CHRG_DET_DIS_CHG_DET		BIT(28)
+
 /* SoC Specific USB2_OTG register definitions */
 #define AM654_USB2_OTG_PD		BIT(8)
 #define AM654_USB2_VBUS_DET_EN		BIT(5)
@@ -43,6 +48,7 @@
 #define OMAP_USB2_HAS_START_SRP			BIT(0)
 #define OMAP_USB2_HAS_SET_VBUS			BIT(1)
 #define OMAP_USB2_CALIBRATE_FALSE_DISCONNECT	BIT(2)
+#define OMAP_USB2_DISABLE_CHRG_DET		BIT(3)
 
 struct omap_usb {
 	struct usb_phy		phy;
@@ -236,6 +242,13 @@ static int omap_usb_init(struct phy *x)
 		omap_usb_writel(phy->phy_base, USB2PHY_ANA_CONFIG1, val);
 	}
 
+	if (phy->flags & OMAP_USB2_DISABLE_CHRG_DET) {
+		val = omap_usb_readl(phy->phy_base, USB2PHY_CHRG_DET);
+		val |= USB2PHY_CHRG_DET_USE_CHG_DET_REG |
+		       USB2PHY_CHRG_DET_DIS_CHG_DET;
+		omap_usb_writel(phy->phy_base, USB2PHY_CHRG_DET, val);
+	}
+
 	return 0;
 }
 
@@ -329,6 +342,26 @@ static const struct of_device_id omap_usb2_id_table[] = {
 };
 MODULE_DEVICE_TABLE(of, omap_usb2_id_table);
 
+static void omap_usb2_init_errata(struct omap_usb *phy)
+{
+	static const struct soc_device_attribute am65x_sr10_soc_devices[] = {
+		{ .family = "AM65X", .revision = "SR1.0" },
+		{ /* sentinel */ }
+	};
+
+	/*
+	 * Errata i2075: USB2PHY: USB2PHY Charger Detect is Enabled by
+	 * Default Without VBUS Presence.
+	 *
+	 * AM654x SR1.0 has a silicon bug due to which D+ is pulled high after
+	 * POR, which could cause enumeration failure with some USB hubs.
+	 * Disabling the USB2_PHY Charger Detect function will put D+
+	 * into the normal state.
+	 */
+	if (soc_device_match(am65x_sr10_soc_devices))
+		phy->flags |= OMAP_USB2_DISABLE_CHRG_DET;
+}
+
 static int omap_usb2_probe(struct platform_device *pdev)
 {
 	struct omap_usb	*phy;
@@ -366,14 +399,14 @@ static int omap_usb2_probe(struct platform_device *pdev)
 	phy->mask		= phy_data->mask;
 	phy->power_on		= phy_data->power_on;
 	phy->power_off		= phy_data->power_off;
+	phy->flags		= phy_data->flags;
+
+	omap_usb2_init_errata(phy);
 
-	if (phy_data->flags & OMAP_USB2_CALIBRATE_FALSE_DISCONNECT) {
 	res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
 	phy->phy_base = devm_ioremap_resource(&pdev->dev, res);
 	if (IS_ERR(phy->phy_base))
 		return PTR_ERR(phy->phy_base);
-		phy->flags |= OMAP_USB2_CALIBRATE_FALSE_DISCONNECT;
-	}
 
 	phy->syscon_phy_power = syscon_regmap_lookup_by_phandle(node,
 							"syscon-phy-power");