Commit aee62305 authored by Jean Delvare's avatar Jean Delvare Committed by Greg Kroah-Hartman

[PATCH] i2c: Suggest N for rare devices in Kconfig

Improve the Kconfig help text of the follwing i2c drivers:
* busses/i2c-pca-isa.c
* chips/pcf8574.c
* chips/pcf8591.c
These are hard to detect and building them into the kernel
results in long delays at boot.

March 2006, thread "I2C_PCA_ISA causes boot delays"
http://marc.theaimsgroup.com/?l=linux-kernel&m=114360399415744&w=2

April 2006, thread "i2c-related 1-minute hang during bootup"
http://marc.theaimsgroup.com/?l=linux-kernel&m=114640992330721&w=2Signed-off-by: default avatarJean Delvare <khali@linux-fr.org>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@suse.de>
parent 177d165d
......@@ -503,6 +503,7 @@ config I2C_PCA_ISA
tristate "PCA9564 on an ISA bus"
depends on I2C
select I2C_ALGOPCA
default n
help
This driver supports ISA boards using the Philips PCA 9564
Parallel bus to I2C bus controller
......@@ -510,6 +511,11 @@ config I2C_PCA_ISA
This driver can also be built as a module. If so, the module
will be called i2c-pca-isa.
This device is almost undetectable and using this driver on a
system which doesn't have this device will result in long
delays when I2C/SMBus chip drivers are loaded (e.g. at boot
time). If unsure, say N.
config I2C_MV64XXX
tristate "Marvell mv64xxx I2C Controller"
depends on I2C && MV64X60 && EXPERIMENTAL
......
......@@ -39,6 +39,7 @@ config SENSORS_EEPROM
config SENSORS_PCF8574
tristate "Philips PCF8574 and PCF8574A"
depends on I2C && EXPERIMENTAL
default n
help
If you say yes here you get support for Philips PCF8574 and
PCF8574A chips.
......@@ -46,6 +47,9 @@ config SENSORS_PCF8574
This driver can also be built as a module. If so, the module
will be called pcf8574.
These devices are hard to detect and rarely found on mainstream
hardware. If unsure, say N.
config SENSORS_PCA9539
tristate "Philips PCA9539 16-bit I/O port"
depends on I2C && EXPERIMENTAL
......@@ -59,12 +63,16 @@ config SENSORS_PCA9539
config SENSORS_PCF8591
tristate "Philips PCF8591"
depends on I2C && EXPERIMENTAL
default n
help
If you say yes here you get support for Philips PCF8591 chips.
This driver can also be built as a module. If so, the module
will be called pcf8591.
These devices are hard to detect and rarely found on mainstream
hardware. If unsure, say N.
config ISP1301_OMAP
tristate "Philips ISP1301 with OMAP OTG"
depends on I2C && ARCH_OMAP_OTG
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment