bnx2x: Obtain Bus Device Function from register

BDF was obtained from kernel but since in virtualized environment
(e.g. physical device assigment in KVM) the function number may
not be the real one, the info must be obtained from the device.
Signed-off-by: Ariel Elior <ariele@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c

@@ -10546,6 +10546,7 @@ static int __devinit bnx2x_init_dev(struct pci_dev *pdev,
 {
 	struct bnx2x *bp;
 	int rc;
+	u32 pci_cfg_dword;
 	bool chip_is_e1x = (board_type == BCM57710 ||
 			    board_type == BCM57711 ||
 			    board_type == BCM57711E);
@@ -10556,7 +10557,6 @@ static int __devinit bnx2x_init_dev(struct pci_dev *pdev,
 	bp->dev = dev;
 	bp->pdev = pdev;
 	bp->flags = 0;
-	bp->pf_num = PCI_FUNC(pdev->devfn);
 
 	rc = pci_enable_device(pdev);
 	if (rc) {
@@ -10623,6 +10623,21 @@ static int __devinit bnx2x_init_dev(struct pci_dev *pdev,
 		goto err_out_release;
 	}
 
+	/* In E1/E1H use pci device function given by kernel.
+	 * In E2/E3 read physical function from ME register since these chips
+	 * support Physical Device Assignment where kernel BDF maybe arbitrary
+	 * (depending on hypervisor).
+	 */
+	if (chip_is_e1x)
+		bp->pf_num = PCI_FUNC(pdev->devfn);
+	else {/* chip is E2/3*/
+		pci_read_config_dword(bp->pdev,
+				      PCICFG_ME_REGISTER, &pci_cfg_dword);
+		bp->pf_num = (u8)((pci_cfg_dword & ME_REG_ABS_PF_NUM) >>
+		    ME_REG_ABS_PF_NUM_SHIFT);
+	}
+	DP(BNX2X_MSG_SP, "me reg PF num: %d\n", bp->pf_num);
+
 	bnx2x_set_power_state(bp, PCI_D0);
 
 	/* clean indirect addresses */

drivers/net/ethernet/broadcom/bnx2x/bnx2x_reg.h

@@ -6024,6 +6024,7 @@
 #define PCICFG_MSI_CONTROL_MSI_PVMASK_CAPABLE	(0x1<<24)
 #define PCICFG_GRC_ADDRESS				0x78
 #define PCICFG_GRC_DATA				0x80
+#define PCICFG_ME_REGISTER				0x98
 #define PCICFG_MSIX_CAP_ID_OFFSET			0xa0
 #define PCICFG_MSIX_CONTROL_TABLE_SIZE		(0x7ff<<16)
 #define PCICFG_MSIX_CONTROL_RESERVED		(0x7<<27)