qlcnic: Enable IPv6 LRO even if IP address is not programmed

o Enabling BIT_9 while configuring hardware LRO allows adapter to
  perform LRO even if destination IP address is not programmed in adapter.
Signed-off-by: Shahed Shaikh <shahed.shaikh@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/qlogic/qlcnic/qlcnic_hw.c

@@ -782,8 +782,8 @@ void qlcnic_82xx_config_intr_coalesce(struct qlcnic_adapter *adapter)
 			"Could not send interrupt coalescing parameters\n");
 }
 
-#define QLCNIC_ENABLE_IPV4_LRO		1
-#define QLCNIC_ENABLE_IPV6_LRO		2
+#define QLCNIC_ENABLE_IPV4_LRO		BIT_0
+#define QLCNIC_ENABLE_IPV6_LRO		(BIT_1 | BIT_9)
 
 int qlcnic_82xx_config_hw_lro(struct qlcnic_adapter *adapter, int enable)
 {