Commit ec61168b authored by Peter Rosin's avatar Peter Rosin Committed by Linus Walleij

pinctrl: sx150x: support setting multiple pins at once

If the chip does not have an oscio pin, all pins are configured in
the same regmap register making it trivial to update all pins at
once, so do that. If an oscio pin is present, there needs to be
more locking in place to handle all cases correctly, so this is
skipped.
Signed-off-by: default avatarPeter Rosin <peda@axentia.se>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
parent 7bd47496
...@@ -395,6 +395,15 @@ static void sx150x_gpio_set(struct gpio_chip *chip, unsigned int offset, ...@@ -395,6 +395,15 @@ static void sx150x_gpio_set(struct gpio_chip *chip, unsigned int offset,
} }
static void sx150x_gpio_set_multiple(struct gpio_chip *chip,
unsigned long *mask,
unsigned long *bits)
{
struct sx150x_pinctrl *pctl = gpiochip_get_data(chip);
regmap_write_bits(pctl->regmap, pctl->data->reg_data, *mask, *bits);
}
static int sx150x_gpio_direction_input(struct gpio_chip *chip, static int sx150x_gpio_direction_input(struct gpio_chip *chip,
unsigned int offset) unsigned int offset)
{ {
...@@ -1075,6 +1084,14 @@ static int sx150x_probe(struct i2c_client *client, ...@@ -1075,6 +1084,14 @@ static int sx150x_probe(struct i2c_client *client,
pctl->gpio.of_node = dev->of_node; pctl->gpio.of_node = dev->of_node;
#endif #endif
pctl->gpio.can_sleep = true; pctl->gpio.can_sleep = true;
/*
* Setting multiple pins is not safe when all pins are not
* handled by the same regmap register. The oscio pin (present
* on the SX150X_789 chips) lives in its own register, so
* would require locking that is not in place at this time.
*/
if (pctl->data->model != SX150X_789)
pctl->gpio.set_multiple = sx150x_gpio_set_multiple;
ret = devm_gpiochip_add_data(dev, &pctl->gpio, pctl); ret = devm_gpiochip_add_data(dev, &pctl->gpio, pctl);
if (ret) if (ret)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment