Commit fba1c627 authored by Emmanuel Grumbach's avatar Emmanuel Grumbach

iwlwifi: pcie: allow the op_mode to call stop_device whenever it wants

Calling stop_device when start_fw wasn't called would issue:
Stopping tx queues that aren't allocated...

Also allow the op_mode to call stop_device and then to
disable the Tx queues - in that case just silently ignore
the disabling on the Tx queues, since the PRPH registers
aren't reachable any more.
Signed-off-by: default avatarEmmanuel Grumbach <emmanuel.grumbach@intel.com>
parent 3dc3374f
......@@ -622,6 +622,10 @@ static inline int iwl_trans_send_cmd(struct iwl_trans *trans,
{
int ret;
if (unlikely(!(cmd->flags & CMD_SEND_IN_RFKILL) &&
test_bit(STATUS_RFKILL, &trans->status)))
return -ERFKILL;
if (unlikely(test_bit(STATUS_FW_ERROR, &trans->status)))
return -EIO;
......@@ -684,9 +688,6 @@ static inline void iwl_trans_reclaim(struct iwl_trans *trans, int queue,
static inline void iwl_trans_txq_disable(struct iwl_trans *trans, int queue)
{
if (unlikely(trans->state != IWL_TRANS_FW_ALIVE))
IWL_ERR(trans, "%s bad state = %d", __func__, trans->state);
trans->ops->txq_disable(trans, queue);
}
......
......@@ -758,11 +758,17 @@ int iwl_pcie_tx_stop(struct iwl_trans *trans)
}
spin_unlock(&trans_pcie->irq_lock);
if (!trans_pcie->txq) {
IWL_WARN(trans,
"Stopping tx queues that aren't allocated...\n");
/*
* This function can be called before the op_mode disabled the
* queues. This happens when we have an rfkill interrupt.
* Since we stop Tx altogether - mark the queues as stopped.
*/
memset(trans_pcie->queue_stopped, 0, sizeof(trans_pcie->queue_stopped));
memset(trans_pcie->queue_used, 0, sizeof(trans_pcie->queue_used));
/* This can happen: start_hw, stop_device */
if (!trans_pcie->txq)
return 0;
}
/* Unmap DMA from host system and free skb's */
for (txq_id = 0; txq_id < trans->cfg->base_params->num_of_queues;
......@@ -1150,8 +1156,15 @@ void iwl_trans_pcie_txq_disable(struct iwl_trans *trans, int txq_id)
SCD_TX_STTS_QUEUE_OFFSET(txq_id);
static const u32 zero_val[4] = {};
/*
* Upon HW Rfkill - we stop the device, and then stop the queues
* in the op_mode. Just for the sake of the simplicity of the op_mode,
* allow the op_mode to call txq_disable after it already called
* stop_device.
*/
if (!test_and_clear_bit(txq_id, trans_pcie->queue_used)) {
WARN_ONCE(1, "queue %d not used", txq_id);
WARN_ONCE(test_bit(STATUS_DEVICE_ENABLED, &trans->status),
"queue %d not used", txq_id);
return;
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment