Superblock (and its copies) is the only data structure in btrfs which
has a fixed location on a device. Since we cannot overwrite in a
sequential write required zone, we cannot place superblock in the zone.
One easy solution is limiting superblock and copies to be placed only in
conventional zones.  However, this method has two downsides: one is
reduced number of superblock copies. The location of the second copy of
superblock is 256GB, which is in a sequential write required zone on
typical devices in the market today.  So, the number of superblock and
copies is limited to be two.  Second downside is that we cannot support
devices which have no conventional zones at all.

To solve these two problems, we employ superblock log writing. It uses
two adjacent zones as a circular buffer to write updated superblocks.
Once the first zone is filled up, start writing into the second one.
Then, when both zones are filled up and before starting to write to the
first zone again, it reset the first zone.

We can determine the position of the latest superblock by reading write
pointer information from a device. One corner case is when both zones
are full. For this situation, we read out the last superblock of each
zone, and compare them to determine which zone is older.

The following zones are reserved as the circular buffer on ZONED btrfs.

- The primary superblock: zones 0 and 1
- The first copy: zones 16 and 17
- The second copy: zones 1024 or zone at 256GB which is minimum, and
  next to it

If these reserved zones are conventional, superblock is written fixed at
the start of the zone without logging.
Signed-off-by: Naohiro Aota <naohiro.aota@wdc.com>
Reviewed-by: David Sterba <dsterba@suse.com>
Signed-off-by: David Sterba <dsterba@suse.com>