-
Gianluca Anzolin authored
When the dlc is closed, rfcomm_dev_state_change() tries to release the port in the case it cannot get a reference to the tty. However this is racy and not even needed. Infact as Peter Hurley points out: 1. Only consider dlcs that are 'stolen' from a connected socket, ie. reused. Allocated dlcs cannot have been closed prior to port activate and so for these dlcs a tty reference will always be avail in rfcomm_dev_state_change() -- except for the conditions covered by #2b below. 2. If a tty was at some point previously created for this rfcomm, then either (a) the tty reference is still avail, so rfcomm_dev_state_change() will perform a hangup. So nothing to do, or, (b) the tty reference is no longer avail, and the tty_port will be destroyed by the last tty_port_put() in rfcomm_tty_cleanup. Again, no action required. 3. Prior to obtaining the dlc lock in rfcomm_dev_add(), rfcomm_dev_state_change() will not 'see' a rfcomm_dev so nothing to do here. 4. After releasing the dlc lock in rfcomm_dev_add(), rfcomm_dev_state_change() will 'see' an incomplete rfcomm_dev if a tty reference could not be obtained. Again, the best thing to do here is nothing. Any future attempted open() will block on rfcomm_dev_carrier_raised(). The unconnected device will exist until released by ioctl(RFCOMMRELEASEDEV). The patch removes the aforementioned code and uses the tty_port_tty_hangup() helper to hangup the tty. Signed-off-by:
Gianluca Anzolin <gianluca@sottospazio.it> Reviewed-by:
Peter Hurley <peter@hurleysoftware.com> Signed-off-by:
Gustavo Padovan <gustavo.padovan@collabora.co.uk>
29cd718b