Pull pci updates from Bjorn Helgaas:
 "Enumeration:

   - Wait for device readiness after reset by polling Vendor ID and
     looking for Configuration RRS instead of polling the Command
     register and looking for non-error completions, to avoid hardware
     retries done for RRS on non-Vendor ID reads (Bjorn Helgaas)

   - Rename CRS Completion Status to RRS ('Request Retry Status') to
     match PCIe r6.0 spec usage (Bjorn Helgaas)

   - Clear LBMS bit after a manual link retrain so we don't try to
     retrain a link when there's no downstream device anymore (Maciej W.
     Rozycki)

   - Revert to the original link speed after retraining fails instead of
     leaving it restricted to 2.5GT/s, so a future device has a chance
     to use higher speeds (Maciej W. Rozycki)

   - Wait for each level of downstream bus, not just the first, to
     become accessible before restoring devices on that bus (Ilpo
     Järvinen)

   - Add ARCH_PCI_DEV_GROUPS so s390 can add its own attribute_groups
     without having to stomp on the core's pdev->dev.groups (Lukas
     Wunner)

  Driver binding:

   - Export pcim_request_region(), a managed counterpart of
     pci_request_region(), for use by drivers (Philipp Stanner)

   - Export pcim_iomap_region() and deprecate pcim_iomap_regions()
     (Philipp Stanner)

   - Request the PCI BAR used by xboxvideo (Philipp Stanner)

   - Request and map drm/ast BARs with pcim_iomap_region() (Philipp
     Stanner)

  MSI:

   - Add MSI_FLAG_NO_AFFINITY flag for devices that mux MSIs onto a
     single IRQ line and cannot set the affinity of each MSI to a
     specific CPU core (Marek Vasut)

   - Use MSI_FLAG_NO_AFFINITY and remove unnecessary .irq_set_affinity()
     implementations in aardvark, altera, brcmstb, dwc, mediatek-gen3,
     mediatek, mobiveil, plda, rcar, tegra, vmd, xilinx-nwl,
     xilinx-xdma, and xilinx drivers to avoid 'IRQ: set affinity failed'
     warnings (Marek Vasut)

  Power management:

   - Add pwrctl support for ATH11K inside the WCN6855 package (Konrad
     Dybcio)

  PCI device hotplug:

   - Remove unnecessary hpc_ops struct from shpchp (ngn)

   - Check for PCI_POSSIBLE_ERROR(), not 0xffffffff, in cpqphp
     (weiyufeng)

  Virtualization:

   - Mark Creative Labs EMU20k2 INTx masking as broken (Alex Williamson)

   - Add an ACS quirk for Qualcomm SA8775P, which doesn't advertise ACS
     but does provide ACS-like features (Subramanian Ananthanarayanan)

  IOMMU:

   - Add function 0 DMA alias quirk for Glenfly Arise audio function,
     which uses the function 0 Requester ID (WangYuli)

  NPEM:

   - Add Native PCIe Enclosure Management (NPEM) support for sysfs
     control of NVMe RAID storage indicators (ok/fail/locate/
     rebuild/etc) (Mariusz Tkaczyk)

   - Add support for the ACPI _DSM PCIe SSD status LED management, which
     is functionally similar to NPEM but mediated by platform firmware
     (Mariusz Tkaczyk)

  Device trees:

   - Drop minItems and maxItems from ranges in PCI generic host binding
     since host bridges may have several MMIO and I/O port apertures
     (Frank Li)

   - Add kirin, rcar-gen2, uniphier DT binding top-level constraints for
     clocks (Krzysztof Kozlowski)

  Altera PCIe controller driver:

   - Convert altera DT bindings from text to YAML (Matthew Gerlach)

   - Replace TLP_REQ_ID() with macro PCI_DEVID(), which does the same
     thing and is what other drivers use (Jinjie Ruan)

  Broadcom STB PCIe controller driver:

   - Add DT binding maxItems for reset controllers (Jim Quinlan)

   - Use the 'bridge' reset method if described in the DT (Jim Quinlan)

   - Use the 'swinit' reset method if described in the DT (Jim Quinlan)

   - Add 'has_phy' so the existence of a 'rescal' reset controller
     doesn't imply software control of it (Jim Quinlan)

   - Add support for many inbound DMA windows (Jim Quinlan)

   - Rename SoC 'type' to 'soc_base' express the fact that SoCs come in
     families of multiple similar devices (Jim Quinlan)

   - Add Broadcom 7712 DT description and driver support (Jim Quinlan)

   - Sort enums, pcie_offsets[], pcie_cfg_data, .compatible strings for
     maintainability (Bjorn Helgaas)

  Freescale i.MX6 PCIe controller driver:

   - Add imx6q-pcie 'dbi2' and 'atu' reg-names for i.MX8M Endpoints
     (Richard Zhu)

   - Fix a code restructuring error that caused i.MX8MM and i.MX8MP
     Endpoints to fail to establish link (Richard Zhu)

   - Fix i.MX8MP Endpoint occasional failure to trigger MSI by enforcing
     outbound alignment requirement (Richard Zhu)

   - Call phy_power_off() in the .probe() error path (Frank Li)

   - Rename internal names from imx6_* to imx_* since i.MX7/8/9 are also
     supported (Frank Li)

   - Manage Refclk by using SoC-specific callbacks instead of switch
     statements (Frank Li)

   - Manage core reset by using SoC-specific callbacks instead of switch
     statements (Frank Li)

   - Expand comments for erratum ERR010728 workaround (Frank Li)

   - Use generic PHY APIs to configure mode, speed, and submode, which
     is harmless for devices that implement their own internal PHY
     management and don't set the generic imx_pcie->phy (Frank Li)

   - Add i.MX8Q (i.MX8QM, i.MX8QXP, and i.MX8DXL) DT binding and driver
     Root Complex support (Richard Zhu)

  Freescale Layerscape PCIe controller driver:

   - Replace layerscape-pcie DT binding compatible fsl,lx2160a-pcie with
     fsl,lx2160ar2-pcie (Frank Li)

   - Add layerscape-pcie DT binding deprecated 'num-viewport' property
     to address a DT checker warning (Frank Li)

   - Change layerscape-pcie DT binding 'fsl,pcie-scfg' to phandle-array
     (Frank Li)

  Loongson PCIe controller driver:

   - Increase max PCI hosts to 8 for Loongson-3C6000 and newer chipsets
     (Huacai Chen)

  Marvell Aardvark PCIe controller driver:

   - Fix issue with emulating Configuration RRS for two-byte reads of
     Vendor ID; previously it only worked for four-byte reads (Bjorn
     Helgaas)

  MediaTek PCIe Gen3 controller driver:

   - Add per-SoC struct mtk_gen3_pcie_pdata to support multiple SoC
     types (Lorenzo Bianconi)

   - Use reset_bulk APIs to manage PHY reset lines (Lorenzo Bianconi)

   - Add DT and driver support for Airoha EN7581 PCIe controller
     (Lorenzo Bianconi)

  Qualcomm PCIe controller driver:

   - Update qcom,pcie-sc7280 DT binding with eight interrupts (Rayyan
     Ansari)

   - Add back DT 'vddpe-3v3-supply', which was incorrectly removed
     earlier (Johan Hovold)

   - Drop endpoint redundant masking of global IRQ events (Manivannan
     Sadhasivam)

   - Clarify unknown global IRQ message and only log it once to avoid a
     flood (Manivannan Sadhasivam)

   - Add 'linux,pci-domain' property to endpoint DT binding (Manivannan
     Sadhasivam)

   - Assign PCI domain number for endpoint controllers (Manivannan
     Sadhasivam)

   - Add 'qcom_pcie_ep' and the PCI domain number to IRQ names for
     endpoint controller (Manivannan Sadhasivam)

   - Add global SPI interrupt for PCIe link events to DT binding
     (Manivannan Sadhasivam)

   - Add global RC interrupt handler to handle 'Link up' events and
     automatically enumerate hot-added devices (Manivannan Sadhasivam)

   - Avoid mirroring of DBI and iATU register space so it doesn't
     overlap BAR MMIO space (Prudhvi Yarlagadda)

   - Enable controller resources like PHY only after PERST# is
     deasserted to partially avoid the problem that the endpoint SoC
     crashes when accessing things when Refclk is absent (Manivannan
     Sadhasivam)

   - Add 16.0 GT/s equalization and RX lane margining settings (Shashank
     Babu Chinta Venkata)

   - Pass domain number to pci_bus_release_domain_nr() explicitly to
     avoid a NULL pointer dereference (Manivannan Sadhasivam)

  Renesas R-Car PCIe controller driver:

   - Make the read-only const array 'check_addr' static (Colin Ian King)

   - Add R-Car V4M (R8A779H0) PCIe host and endpoint to DT binding
     (Yoshihiro Shimoda)

  TI DRA7xx PCIe controller driver:

   - Request IRQF_ONESHOT for 'dra7xx-pcie-main' IRQ since the primary
     handler is NULL (Siddharth Vadapalli)

   - Handle IRQ request errors during root port and endpoint probe
     (Siddharth Vadapalli)

  TI J721E PCIe driver:

   - Add DT 'ti,syscon-acspcie-proxy-ctrl' and driver support to enable
     the ACSPCIE module to drive Refclk for the Endpoint (Siddharth
     Vadapalli)

   - Extract the cadence link setup from cdns_pcie_host_setup() so link
     setup can be done separately during resume (Thomas Richard)

   - Add T_PERST_CLK_US definition for the mandatory delay between
     Refclk becoming stable and PERST# being deasserted (Thomas Richard)

   - Add j721e suspend and resume support (Théo Lebrun)

  TI Keystone PCIe controller driver:

   - Fix NULL pointer checking when applying MRRS limitation quirk for
     AM65x SR 1.0 Errata #i2037 (Dan Carpenter)

  Xilinx NWL PCIe controller driver:

   - Fix off-by-one error in INTx IRQ handler that caused INTx
     interrupts to be lost or delivered as the wrong interrupt (Sean
     Anderson)

   - Rate-limit misc interrupt messages (Sean Anderson)

   - Turn off the clock on probe failure and device removal (Sean
     Anderson)

   - Add DT binding and driver support for enabling/disabling PHYs (Sean
     Anderson)

   - Add PCIe phy bindings for the ZCU102 (Sean Anderson)

  Xilinx XDMA PCIe controller driver:

   - Add support for Xilinx QDMA Soft IP PCIe Root Port Bridge to DT
     binding and xilinx-dma-pl driver (Thippeswamy Havalige)

  Miscellaneous:

   - Fix buffer overflow in kirin_pcie_parse_port() (Alexandra Diupina)

   - Fix minor kerneldoc issues and typos (Bjorn Helgaas)

   - Use PCI_DEVID() macro in aer_inject() instead of open-coding it
     (Jinjie Ruan)

   - Check pcie_find_root_port() return in x86 fixups to avoid NULL
     pointer dereferences (Samasth Norway Ananda)

   - Make pci_bus_type constant (Kunwu Chan)

   - Remove unused declarations of __pci_pme_wakeup() and
     pci_vpd_release() (Yue Haibing)

   - Remove any leftover .*.cmd files with make clean (zhang jiao)

   - Remove unused BILLION macro (zhang jiao)"

* tag 'pci-v6.12-changes' of git://git.kernel.org/pub/scm/linux/kernel/git/pci/pci: (132 commits)
  PCI: Fix typos
  dt-bindings: PCI: qcom: Allow 'vddpe-3v3-supply' again
  tools: PCI: Remove unused BILLION macro
  tools: PCI: Remove .*.cmd files with make clean
  PCI: Pass domain number to pci_bus_release_domain_nr() explicitly
  PCI: dra7xx: Fix error handling when IRQ request fails in probe
  PCI: dra7xx: Fix threaded IRQ request for "dra7xx-pcie-main" IRQ
  PCI: qcom: Add RX lane margining settings for 16.0 GT/s
  PCI: qcom: Add equalization settings for 16.0 GT/s
  PCI: dwc: Always cache the maximum link speed value in dw_pcie::max_link_speed
  PCI: dwc: Rename 'dw_pcie::link_gen' to 'dw_pcie::max_link_speed'
  PCI: qcom-ep: Enable controller resources like PHY only after refclk is available
  PCI: Mark Creative Labs EMU20k2 INTx masking as broken
  dt-bindings: PCI: imx6q-pcie: Add reg-name "dbi2" and "atu" for i.MX8M PCIe Endpoint
  dt-bindings: PCI: altera: msi: Convert to YAML
  PCI: imx6: Add i.MX8Q PCIe Root Complex (RC) support
  PCI: Rename CRS Completion Status to RRS
  PCI: aardvark: Correct Configuration RRS checking
  PCI: Wait for device readiness with Configuration RRS
  PCI: brcmstb: Sort enums, pcie_offsets[], pcie_cfg_data, .compatible strings
  ...