When used in Extended SPI mode on LS1021A, the DSPI controller wants to
have the least significant 16-bit word written first to the TX FIFO.

In fact, the LS1021A reference manual says:

33.5.2.4.2 Draining the TX FIFO

When Extended SPI Mode (DSPIx_MCR[XSPI]) is enabled, if the frame size
of SPI Data to be transmitted is more than 16 bits, then it causes two
Data entries to be popped from TX FIFO simultaneously which are
transferred to the shift register. The first of the two popped entries
forms the 16 least significant bits of the SPI frame to be transmitted.

So given the following TX buffer:

 +-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+
 | 0x0 | 0x1 | 0x2 | 0x3 | 0x4 | 0x5 | 0x6 | 0x7 | 0x8 | 0x9 | 0xa | 0xb |
 +-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+
 |     32-bit word 1     |     32-bit word 2     |     32-bit word 3     |
 +-----------------------+-----------------------+-----------------------+

The correct way that a little-endian system should transmit it on the
wire when bits_per_word is 32 is:

0x03020100
0x07060504
0x0b0a0908

But it is actually transmitted as following, as seen with a scope:

0x01000302
0x05040706
0x09080b0a

It appears that this patch has been submitted at least once before:
https://lkml.org/lkml/2018/9/21/286
but in that case Chuanhua Han did not manage to explain the problem
clearly enough and the patch did not get merged, leaving XSPI mode
broken.

Fixes: 8fcd151d ("spi: spi-fsl-dspi: XSPI FIFO handling (in TCFQ mode)")
Cc: Esben Haabendal <eha@deif.com>
Cc: Chuanhua Han <chuanhua.han@nxp.com>
Signed-off-by: Vladimir Oltean <olteanv@gmail.com>
Link: https://lore.kernel.org/r/20191228135536.14284-1-olteanv@gmail.comSigned-off-by: Mark Brown <broonie@kernel.org>
Cc: stable@vger.kernel.org