GitLab

cqspi_enable_dtr() is called for each operation, commands or not, reads
or writes. It writes CQSPI_REG_CONFIG then waits for idle (three
successful reads). Skip that in the no-DTR case if DTR is already
disabled.

It cannot be skipped in the DTR case as cqspi_setup_opcode_ext() writes
to a register and we must wait for idle state.

According to ftrace, the average cqspi_exec_mem_op() call goes from
85.4µs to 83.6µs when reading 235M over UBIFS on an octal flash.
Signed-off-by: Théo Lebrun <theo.lebrun@bootlin.com>
Link: https://msgid.link/r/20240405-cdns-qspi-mbly-v2-6-956679866d6d@bootlin.com

Signed-off-by: Mark Brown <broonie@kernel.org>