Atm, igt/gem_reset_stats can trigger the recently added WARN on
left-over PM_IIR bits in gen6_enable_rps_interrupts(). There are two
reasons for this:
1. we call intel_enable_gt_powersave() without a preceeding
   intel_disable_gt_powersave()
2. gen6_disable_rps_interrupts() doesn't mask interrupts in PM_IMR

1. means RPS interrupts will remain enabled and can be serviced during
the HW initialization after a GPU reset. 2. means even if we called
gen6_disable_rps_interrupts() any new RPS interrupt during RPS
initialization would still propagate to PM_IIR too early (though
wouldn't be serviced).

This patch solves the 2. issue by also masking interrupts in PM_IMR, the
following patch fixes 1. getting rid of the WARN. This also makes
intel_enable_gt_powersave() and intel_disable_gt_powersave() more
symmetric.

Since gen6_disable_rps_interrupts() is called during driver loading with
i915 interrupts disabled add a new version of gen6_disable_pm_irq() that
doesn't WARN for this.

Also while at it, get the irq_lock around the whole PM_IMR/IER/IIR
programming sequence and make sure that any queued PM_IIR bit is also
cleared.

The WARN was caught by PRTS after I sent my previous RPS sanitizing
patchset and I could easily reproduce it on HSW. To actually fix it we
also need the next patch.
Reported-by: He, Shuang <shuang.he@intel.com>
Signed-off-by: Imre Deak <imre.deak@intel.com>
Reviewed-by: Paulo Zanoni <paulo.r.zanoni@intel.com>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>