In the current setup the PA is left unmuted even when the
Soundwire ports are not started streaming. This can lead to click
and pop sounds during start.
There is a same issue in the reverse order where in the PA is
left unmute even after the data stream is stopped, the time
between data stream stopping and port closing is long enough
to accumulate DC on the line resulting in Click/Pop noise
during end of stream.

making use of new mute_unmute_on_trigger flag is helping a
lot with this Click/Pop issues reported on this Codec
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Tested-by: Johan Hovold <johan+linaro@kernel.org>
Link: https://lore.kernel.org/r/20231027105747.32450-3-srinivas.kandagatla@linaro.orgSigned-off-by: Mark Brown <broonie@kernel.org>