During test of one IB card with guest VM, found that, msi is not
initialized properly.

It turns out __write_msi_msg will do nothing if device current_state is
not PCI_D0.  And, that pci device does not have pm_cap in guest VM.

There is an error in setting of power state to PCI_D0 in
pci_enable_device(), but error is not returned for this.  Following is
code flow:

pci_enable_device() -->   __pci_enable_device_flags() -->
do_pci_enable_device() -->   pci_set_power_state() -->
__pci_start_power_transition()

We have following condition inside __pci_start_power_transition():
         if (platform_pci_power_manageable(dev)) {
                 error = platform_pci_set_power_state(dev, state);
                 if (!error)
                         pci_update_current_state(dev, state);
         } else {
                 error = -ENODEV;
                 /* Fall back to PCI_D0 if native PM is not supported */
                 if (!dev->pm_cap)
                         dev->current_state = PCI_D0;
         }

Here, from platform_pci_set_power_state(), acpi_pci_set_power_state() is
getting called and that is failing with ENODEV because of following
condition:

         if (!handle || ACPI_SUCCESS(acpi_get_handle(handle, "_EJ0",&tmp)))
                 return -ENODEV;

Because of that, pci_update_current_state() is not getting called.

With this patch, if device power state can not be set via
platform_pci_set_power_state and that device does not have native pm
support, then PCI device power state will be set to PCI_D0.

-v2: This also reverts 47e9037a, as it's
     not needed after this change.
Acked-by: "Rafael J. Wysocki" <rjw@sisk.pl>
Signed-off-by: Ajaykumar Hotchandani<ajaykumar.hotchandani@oracle.com>
Signed-off-by: Yinghai Lu<yinghai.lu@oracle.com>
Signed-off-by: Jesse Barnes <jbarnes@virtuousgeek.org>