Pull ARM SoC cleanups from Arnd Bergmann:
 "The cleanups for v4.9 are a little larger that usual, but thankfully
  that is almost exclusively due to removing a significant number of
  files that have become obsolete after the still ongoing conversion of
  old board files to devicetree.

   - for mach-omap2, which is still the largest platform in arch/arm/,
     the conversion to DT is finally complete after the Nokia N900 is
     now fully supported there, along with the omap3 LDP, and we can
     remove those two board files. If no regressions are found, another
     large cleanup for the platform will happen as a follow-up, removing
     dead code and restructuring the platform based on being DT-only.

   - In mach-imx, similar work is ongoing, but has not come that far.
     This time, we remove the obsolete board file for the i.MX1
     generation, which like i.MX25, i.MX5, i.MX6, and i.MX7 is now
     DT-only. The remaining board files are for i.MX2 and i.MX3 machines
     based on old ARM926 or ARM1136 cores that should work with DT in
     principle.

   - realview has just been converted from board files to DT, and a lot
     of code gets removed in the process. This is the last
     ARM/Keil/Versatile derived platform that was still using board
     files, the other ones being integrator, versatile and vexpress. We
     can probably merge the remaining code into a single directory in
     the near future.

   - clps711x had completed the conversion in v4.8, but we accidentally
     left the files in place that should have been deleted then"

* tag 'armsoc-cleanup' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (21 commits)
  ARM: select PCI_DOMAINS config from ARCH_MULTIPLATFORM
  ARM: stop *MIGHT_HAVE_PCI* config from being selected redundantly
  ARM: imx: (trivial) fix typo and grammar
  ARM: clps711x: remove extraneous files
  ARM: imx: use IS_ENABLED() instead of checking for built-in or module
  ARM: OMAP2+: use IS_ENABLED() instead of checking for built-in or module
  ARM: OMAP1: use IS_ENABLED() instead of checking for built-in or module
  ARM: imx: remove platform-mxc_rnga
  ARM: realview: imply device tree boot
  ARM: realview: no need to select SMP_ON_UP explicitly
  ARM: realview: delete the RealView board files
  ARM: imx: no need to select SMP_ON_UP explicitly
  ARM: i.MX: Move SOC_IMX1 into 'Device tree only'
  ARM: i.MX: Remove i.MX1 non-DT support
  ARM: i.MX: Remove i.MX1 Synertronixx SCB9328 board support
  ARM: i.MX: Remove i.MX1 Armadeus APF9328 board support
  ARM: mxs: remove obsolete startup code for TX28
  ARM: i.MX31 iomux: remove duplicates with alternate name
  ARM: i.MX31 iomux: remove plain duplicates
  ARM: OMAP2+: Drop legacy board file for LDP
  ...