This adds initial support for BPF-JIT on MIPS

Tested on mips32 LE/BE and mips64 BE/n64 using
dhcp, ping and various tcpdump filters.

Benchmarking:

Assuming the remote MIPS target uses 192.168.154.181
as its IP address, and the local host uses 192.168.154.136,
the following results can be obtained using the following
tcpdump filter (catches no frames) and a simple
'time ping -f -c 1000000' command.

[root@(none) ~]# tcpdump -p -n -s 0 -i eth0 net 10.0.0.0/24 -d
(000) ldh      [12]
(001) jeq      #0x800           jt 2	jf 8
(002) ld       [26]
(003) and      #0xffffff00
(004) jeq      #0xa000000       jt 16	jf 5
(005) ld       [30]
(006) and      #0xffffff00
(007) jeq      #0xa000000       jt 16	jf 17
(008) jeq      #0x806           jt 10	jf 9
(009) jeq      #0x8035          jt 10	jf 17
(010) ld       [28]
(011) and      #0xffffff00
(012) jeq      #0xa000000       jt 16	jf 13
(013) ld       [38]
(014) and      #0xffffff00
(015) jeq      #0xa000000       jt 16	jf 17
(016) ret      #65535

- BPF-JIT Disabled

real    1m38.005s
user    0m1.510s
sys     0m6.710s

- BPF-JIT Enabled

real    1m35.215s
user    0m1.200s
sys     0m4.140s

[ralf@linux-mips.org: Resolved conflict.]
Signed-off-by: Markos Chandras <markos.chandras@imgtec.com>