• Yuval Mintz's avatar
    bnx2x: Don't flush multicast MACs · c7b7b483
    Yuval Mintz authored
    When ndo_set_rx_mode() is called for bnx2x, as part of process of
    configuring the new MAC address filters [both unicast & multicast]
    driver begins by flushing the existing configuration and then iterating
    over the network device's list of addresses and configures those instead.
    
    This has the side-effect of creating a short gap where traffic wouldn't
    be properly classified, as no filters are configured in HW.
    While for unicasts this is rather insignificant [as unicast MACs don't
    frequently change while interface is actually running],
    for multicast traffic it does pose an issue as there are multicast-based
    networks where new multicast groups would constantly be removed and
    added.
    
    This patch tries to remedy this [at least for the newer adapters] -
    Instead of flushing & reconfiguring all existing multicast filters,
    the driver would instead create the approximate hash match that would
    result from the required filters. It would then compare it against the
    currently configured approximate hash match, and only add and remove the
    delta between those.
    Signed-off-by: default avatarYuval Mintz <Yuval.Mintz@qlogic.com>
    Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
    c7b7b483
bnx2x_sriov.h 19.5 KB