Currently when updating a control that is shared between multiple widgets the
whole power-up/power-down sequence is being run once for each widget. The
control register is updated during the first run, which means the CODEC internal
routing is also updated for all widgets during this first run. The input and
output paths for each widgets are only updated though during the respective run
for that widget. This leads to a slight inconsistency between the CODEC's
internal state and ASoC's state, which causes non optimal behavior in regard to
click and pop avoidance.

E.g. consider the following setup where two MUXs share the same control.

          +------+
 A1 ------|      |
          | MUX1 |----- C1
 B1 ------|      |
          +------+
             |
  control ---+
             |
          +------+
 A2 ------|      |
          | MUX2 |----- C2
 B2 ------|      |
          +------+

If the control is updated to switch the MUXs from input A to input B with the
current code the power-up/power-down sequence will look like this:

Run soc_dapm_mux_update_power for MUX1
  Power-down A1
  Update MUXing
  Power-up B1

Run soc_dapm_mux_update_power for MUX2
  Power-down A2
  (Update MUXing)
  Power-up B2

Note that the second 'Update Muxing' is a no-op, since the register was already
updated.

While the preferred order for avoiding pops and clicks should be:

Run soc_dapm_mux_update_power for control
  Power-down A1
  Power-down A2
  Update MUXing
  Power-up B1
  Power-up B2

This patch changes the behavior to the later by running the updates for all
widgets that the control is attached to at the same time.

The new code is also a bit simpler since callers of
soc_dapm_{mux,muxer}_update_power don't have to loop over each widget anymore
and neither do we need to keep track for which of the kcontrol's widgets the
current update is.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Mark Brown <broonie@linaro.org>