• JC Kuo's avatar
    phy: tegra: xusb: Add Tegra194 support · 1ef535c6
    JC Kuo authored
    Add support for the XUSB pad controller found on Tegra194 SoCs. It is
    mostly similar to the same IP found on Tegra186, but the number of
    pads exposed differs, as do the programming sequences. Because most of
    the Tegra194 XUSB PADCTL registers definition and programming sequence
    are the same as Tegra186, Tegra194 XUSB PADCTL can share the same
    driver, xusb-tegra186.c, with Tegra186 XUSB PADCTL.
    
    Tegra194 XUSB PADCTL supports up to USB 3.1 Gen 2 speed, however, it
    is possible for some platforms have long signal trace that could not
    provide sufficient electrical environment for Gen 2 speed. This patch
    adds a "maximum-speed" property to usb3 ports which can be used to
    specify the maximum supported speed for any particular USB 3.1 port.
    For a port that is not capable of SuperSpeedPlus, "maximum-speed"
    property should carry "super-speed".
    Signed-off-by: default avatarJC Kuo <jckuo@nvidia.com>
    Acked-by: default avatarThierry Reding <treding@nvidia.com>
    Signed-off-by: default avatarThierry Reding <treding@nvidia.com>
    1ef535c6
Makefile 485 Bytes