Here we introduce per-cgroup latency target. The target determines how a
cgroup can afford latency increasement. We will use the target latency
to calculate a threshold and use it to schedule IO for cgroups. If a
cgroup's bandwidth is below its low limit but its average latency is
below the threshold, other cgroups can safely dispatch more IO even
their bandwidth is higher than their low limits. On the other hand, if
the first cgroup's latency is higher than the threshold, other cgroups
are throttled to their low limits. So the target latency determines how
we efficiently utilize free disk resource without sacifice of worload's
IO latency.

For example, assume 4k IO average latency is 50us when disk isn't
congested. A cgroup sets the target latency to 30us. Then the cgroup can
accept 50+30=80us IO latency. If the cgroupt's average IO latency is
90us and its bandwidth is below low limit, other cgroups are throttled
to their low limit. If the cgroup's average IO latency is 60us, other
cgroups are allowed to dispatch more IO. When other cgroups dispatch
more IO, the first cgroup's IO latency will increase. If it increases to
81us, we then throttle other cgroups.

User will configure the interface in this way:
echo "8:16 rbps=2097152 wbps=max latency=100 idle=200" > io.low

latency is in microsecond unit

By default, latency target is 0, which means to guarantee IO latency.
Signed-off-by: Shaohua Li <shli@fb.com>
Signed-off-by: Jens Axboe <axboe@fb.com>